Husqvarna YTH18K46 Operator's Manual

lo que puede producir daños graves en éstos. Siempre use anteojos de seguridad o pro tec cio- nes para los ojos mientras opere su tractor o cuando haga ajustes o reparaciones. Recomenda- mos gafas de seguridad o una máscara de visión amplia de seguridad usada sobre las gafas. COMO USAR SU TRACTOR PARA AJUSTAR EL FRENO DE ES TA CIO NA MIEN- TO (Vea Fig. 4) Su tractor viene equipado con un interruptor sensor que exige la presencia del operador. Cuando el motor está fun- cionando, si el ...

Husqvarna garantiza al comprador minorista original que este producto Husqvarna® carece de defectos materiales o de fabricación para un uso y mantenimiento normales desde el día de la compra, dentro del periodo de garantía aplicable indicado en el Anexo A. Esta Garantía limitada no se podrá transferir a ningún comprador posterior de este producto Husqvarna®. Ciertos componentes (por ejemplo, los motores y las transmisiones) quedan excluidos de la cobertura y se aplican otras limitaciones, según se describe en este doc ...

Gauge wheels are prop er ly ad just ed when they are slight ly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in prop- er position to help prevent scalping in most terrain conditions. NOTE: Adjust gauge wheels with tractor on a flat level surface. • Adjust mower to desired cutting height (See “TO AD JUST MOWER CUT TING HEIGHT” in this sec tion of manual). • With mower in desired height of cut po si tion, gauge wheels should be assembled so they are slightly off the ground ...

in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any ad just ments or repairs. We rec om mend standard safety glasses or a wide vision safety mask worn over spectacles. TO USE THROTTLE CONTROL (D) (See Fig. 6) Always operate engine at full speed (fast). • Operating engine at less than full speed (fast) reduces engines operating efficiency. • Full speed (fast) of fers the best bagging and mower per for mance. HOW TO USE Y ...

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope. • Choose the slowest speed before starting up or down hills. • Avoid stopping or changing speed on hills. REVERSE OPERATION SYSTEM (ROS) (See Fig. 11) Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position. WARNING: Backing up with the attachment clutch en- gaged ...

The tires on your tractor were overinflated at the factory for shipping purposes. Correct tire pressure is important for best cutting performance. • Reduce tire pressure to PSI shown on tires. CHECK DECK LEVELNESS For best cutting results, mower housing should be properly leveled. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual. CHECK FOR PROPER POSITION OF ALL BELTS See the figures that are shown for replacing motion and mower blade drive belts in the Service and Adjustments sec- tion of this manual. Verify that the belt ...

• Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. SERVICE AND ADJUSTMENTS TO REMOVE MOWER (See Fig. 22) • Place attachment clutch in “DIS EN GAGED” position. • Lower attachment lift lever to its lowest position. • R ...