IBM NetVista Hardware Manual

Diagnostic Aids Introduction .......................................................... 72 Power-On Self Test .............................................. 73 Diagnostic Diskette .............................................. 75 Using the Diagnostic Diskette ....................... 75 Using Diagnostic Program from Recovery CD ................................................. 76 Diagnostics Program Features ...................... 77 ...

CD-ROM Drive Rear Panel Connectors and Jumpers NOTE: CD-ROM drives may come with item no. 5 (digital audio output) connectors. CD-ROM Drive Rear Panel Connectors and Jumpers Item Function Connect to... 1 Power supply connector Power supply 2 Interface connector System board CN12: IDE 2 3 Configuration jumper. CS SL MA Description -- -- On Master -- On -- Slave. On -- -- Cable select -- 4 Audio line out connector System board 5 Digital audio output -- ...

Incorrect memory size shown or repeated during POST. 1. Insert the memory modules in the RIMM sockets properly, then reboot the system. 2. Memory module. See “005 -” on page 59 to replace memory module. 3. System board. System works but fails to enter power saving mode when the Power Management Mode is set to [Enabled], and power saving timer set in BIOS has elapsed. 1. Enter Configuration/ Setup Utility and load default settings. 2. In Windows ME or Windows 2K, check settings in Power Management Property of Control Panel. 3. Reload software from Recovery CD. System ha ...

Front Panel • Release the latch that holds the front panel. • Gently remove the front panel from the tower. ...