FRIEDLAND Spectra Plus L420N WHI Instruction Manual

position and then refit the cover and tighten the fixing screws. Important: Do not switch on the power until the installation of the lighting is completed. Testing the Receiver: The Receiver has a built in Test/Manual Operation facility which can be operated by pressing the Learn button for under 1 second. If the lights are OFF, they will be switched on for a period of 5 seconds. If the lights are already ON, pressing the learn button will cancel any remaining time- on period and immediately switch them OFF. 5 Installing the PIR Detector Positioning ...

Important: Before commencing walk test ensure the RED indicator behind the PIR lens is not flashing continuously. If it is wait until the PIR has completed its warm up cycle and the flashing stops. Configure the detector for walk testing as follows: 1) Set the TIME control fully anti-clockwise to its minimum setting. 2) Set the DUSK control fully clockwise to its maximum setting. The PIR will now operate during the day and switchthelightsforitsminimumperiodof5seconds. Slowly walk across the detection area approximately 5m from the unit. As you cross a detection zone and your mo ...

Note: Also refer to the trouble shooting guide in your Chime or Switching Receiver manual. PIR does not detect movement… ●Check that the battery in the PIR is not exhausted. ●Detection area is set incorrectly. PIR does not activate Switching Receiver and lights at all… ●Check that the battery in the PIR is not exhausted. ●Check that the power to the Receiver is switched ON. ●Check the bulb and replace if defective. Ensure that the light bulb is correctly fitted. ●Turn OFF the power ...

into Walk Test, (see “PIR Walk Test”). The Receiver may also be tested on its own by briefly operating the learn button (see “Testing the Receiver”). Expanding or Resetting Your System Your system can be expanded by adding additional PIR detectors and also by linking in Libra Plus door chime pushes. Up to a maximum of 10 PIRs or Chime Pushes may be linked to the receiver. Remember that if you have more than one PIR Detector in the same system the light or lights will stay on until the last detector no longer detects any movement, and ...

into Walk Test, (see “PIR Walk Test”). The Receiver may also be tested on its own by briefly operating the learn button (see “Testing the Receiver”). Expanding or Resetting Your System Your system can be expanded by adding additional PIR detectors and also by linking in Libra Plus door chime pushes. Up to a maximum of 10 PIRs or Chime Pushes may be linked to the receiver. Remember that if you have more than one PIR Detector in the same system the light or lights will stay on until the last detector no longer detects any movement, and ...

the PIR detector is coded with a unique identification code. This code is already learnt into the Receiver when it is supplied. However, if the Receiver does not respond to the PIR it may be necessary to reset the Receiver and relearn the code again. These procedures are described in “Expanding your System” below. Setting the PIR for Automatic NIGHT Operation with a Spectra Plus Switching Receiver: Having completed the ‘walk test’ procedure, you can set the unit for automatic operation as follows: 1) The TIME control d ...