Kyocera KM-8030 Advanced Operation Manual

Total Count by Size, 1-5 You can register specific paper sizes to monitor so that you can check the copy count. You can also register types of paper. NOTE: Up to five different paper sizes can be registered for keeping track of the copy count. If you do not specify the paper type, the registered paper size will be counted regardless of the type. However, if you register a size without specifying the type as the first entry and register the same size with a type as the second entry, t ...

Deletes all documents in the Form Box, Shared Data Box or Synergy Print Box, so that the box is reset to the initial, clean state. Before initializing, be sure that the box does not contain any documents that should not be deleted. 1 Access the Document Management screen. (For instructions, refer to Accessing the Document Management Screen on page 3-42.) 2 Press [Reset Box] for the box to be initialized. 3 Press [Yes] to reset the box to the clean state. All documents contained in the box are deleted. The touch panel will return to the Document Manag ...

prepare single copy jobs if there are too many originals to place at once when using the document processor. Divide the original into smaller sets and scan each set with the document processor. In Batch Scanning mode, you can continue scanning originals until you press [Scanning finished]. Follow the steps as below to use batch scanning. 1 Press [Function]. 2 Press [Batch Scanning]. 3 Press [On]. 4 Place the originals in the document processor or on the platen ...