Lenovo V560 Hardware Maintenance Manual

The new base cover FRU is shipped with a kit containing labels of several kinds. When you replace the base cover, you need to apply the following label: The following labels need to be peeled off from the old base cover, and need to be put on the new base cover. a Wistron Label b PRC/MTM Label c Rating Label d Malaysia Homologation Label e Malaysia Sirim Label (BT) f Brazil Label (WLAN) or WLAN Label for US/CA/TW or Israel LBL for WLAN g PPT Label h Brazil Label (BT) or BT Label for US/CA/TW i Brazil Label (WLAN) or WLAN Label for US/ ...

Important service information This chapter presents the following important service information: • “Strategy for replacing FRUs” on page 16 – “Strategy for replacing a hard disk drive” on page 17 – “Important notice for replacing a system board ” on page 17 • “Strategy for replacing FRUs for CTO, CMV, and GAV” on page 18 – “Product definition” on page 18 – “FRU identification for CTO, CMV, and GAV products” on page 18 • “Important information about replacing RoHS compliant FRUs” on page 20 Important: BIOS ...

DANGER Only use the battery specified in the parts list for your computer. Any other battery could ignite or explode. Figure 1. Removal steps of battery pack Unlock the battery release lever 1. Holding the battery release lever in the unlocked position 2, remove the battery pack in the direction shown by arrow 3. 1 2 3 When installing: Install the battery pack along the slide rails of the slot. Then make sure that the battery release lever is in the locked position. ...

For access, remove these FRUs in order: • “1010 Battery pack” on page 37 • “1030 Hard disk drive(HDD)/Memory/Mini PCI Express Card slot compartment cover” on page 39 Figure 7. Removal steps of PCI Express Mini Card for wireless LAN/WAN 1 2 Disconnect the two wireless LAN cables (black, white) 1, and then remove the screw 2. In step 1, unplug the jacks by using the removal tool antenna RF connector (P/N: 08K7159), or pick up the connectors with your fingers and gently unplug them in the direction shown by arrows. No ...

Important: Use only approved tools and test equipments. Some hand tools have handles covered with a soft material that does not insulate you when working with live electrical currents. Many customers have rubber floor mats near their machines that contain small conductive fibers to decrease electrostatic discharges. Do not use such kind of mat to protect yourself from electrical shock. Find the room emergency power-off (EPO) switch, disconnecting the switch • or electrical outlet. If an ...

1040 Hard disk drive For access, remove these FRUs in order: • “1010 Battery pack” on page 37 • “1030 Hard disk drive(HDD)/Memory/Mini PCI Express Card slot compartment cover” on page 39 Attention: •� Do�not�drop�the�hard�disk�drive�or�apply�any�physical�shock�to�it. The hard disk drive is sensitive to physical shock. Improper handling can cause damages and permanent loss of data. • Before removing the drive, suggest the customer to backup all the information on it if possible. • Never remove the driv ...

• “What to do first” on page 22 • “Power system checkout” on page 23 Before you go to the checkout, make sure to read the following important notes: Important notes: •� Only�certified�trained�personnel�can�service�the�computer. •� Before�replacing�any�FRU,�read�the�entire�page�on�removing�and�replacing� FRUs. •� When�you�replace�FRUs,�use�new�nylon-coated�screws. •� Be�extremely�careful�during�such�write�operations�a ...