Leviton 47691-5MS Quick Install Manual

up to eight satellite receivers. It is designed to work with all DIRECTV Dish Antenna Systems and all generations of DIRECTV satellite receivers. The module also incorporates a separate input to receive TV antenna or CATV signals. 47691-5MS Technical Support: 800-824-3005 www.leviton-lin.com PACKAGE CONTENT 5x8 Multi-Switch 24 VDC Power Supply 6 Push-Lock pins 5x8 BETA GUIDE

Structured Media Center (SMC). For horizonal mounting, snap the supplied grommets in to the locations marked ‘H’. See Figure 1. For vertical mounting, snap the supplied grommets in to the locations marked ‘V’. See Figure 2. Insert the pin plungers in to all 4 locations. With the mounting pin plungers in the out position, press the unit into the grid in the desired locations. Final setting is made by pressing the plunger head in to lock it in place. 2 INSTALLATION Figure 1 Figure 2

3. Connect cables going to the satellite receivers to the “receiver 1 through 8” connectors. 5x8 BETA GUIDE Figure 3

instructions marked on the product. Do not use this product near water - e.g., near a tub, wash basin, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Never push objects of any kind into this product through openings, as they may touch dangerous voltages. SAVE THESE INSTRUCTIONS! 1. 2. 3. 4. SAFETY INFORMATION: Never install communications wiring or components during a lightning storm Never install communications components in wet locations unless components are designed specifically for use in wet locations. Never touch uninsulated wires or terminals unless the wiring has been disconnected at the network interface. Use caution when installing or modifying communications wiring or components. 1. 2. 3. 4. The UHF/VHF input may be used to receive TV antenna or CATV signals. When combining incoming TV antenna or CATV signals with the incoming satellite signal, it is necessary to use a diplexer to separate out signals before connecting to the satellite receivers. For the power connection to the multiswitch: Make a coax jumper cable of the desired length. Connect one end of the jumper to the power connection on the multiswitch. Connect the other end of the jumper to the included power transformer. Plug the power transformer into a powered outlet. Note: Power the multiswitch using the included power supply only, do not power the multiswitch until all other connections are made. • • • •

Little Neck, N.Y. 11362-2591, USA Tech Support: 800-824-3005 5x8 BETA GUIDE