Escort Passport SRX Installation Manual

Front Radar Receiver 1 Determine the best location for the radar receiver. The best location is typically under the bumper, or inside the front grill of the vehicle. For the best radar performance, install the radar receiver horizontally, with a clear “view” of the road. 2 Using the built-in mounting holes on the receiver, or the supplied right-angle mounting bracket, mark location. Drill pilot holes in the vehicle if necessary. 3 Mount radar receiver using the supplied hardware. (If right-angle mounting bracket is used, secure radar receiver to the right-angle bracket first, then install bracket with radar receiver to the vehicle.) Note: 1. Do not drill holes in the receiver itself. 2. Thoroughly investigate location before drilling any holes. 3. Keep all cables away from moving parts, and hot surfaces (radiator, hoses, etc.). 4. Do not splice cable. Radar Receiver Cable 1 Connect the receiver cable to the receiver. 2 Route cable to firewall, and secure with zip- ties (included). 3 Route receiver cable into the vehicle’s interior. If there is not a suitable opening, drill a 13/32" or 7/16" hole. 4 Pull cable through firewall, and plug connector into the jack labeled “Front Radar” on the Interface. 5 Pull grommet (located on the receiver cable itself) through the firewall to seal the hole. Use silicone sealant (not supplied) if necessary. Note: 1. Connection between the radar receiver, an the receiver cable, must be located in a dry location under hood. 2. Only drill hole in firewall after thoroughly investigating location first, ensuring no other wires, hoses, etc. will be damaged. 3. Keep all cables away from moving parts, and hot surfaces (radiator, hoses, etc.). 4. Do not splice cable. Front Laser Shifters 1 Determine best location for the Laser Shifters. For optimum performance, install each laser shifter on either side of the front license plate, with a clear “view” of the road. If possible, center each shifter module between the license plate, and the outside edge of the vehicle. (see photo above) 2 Using the supplied mounting bracket, mark location. Drill pilot holes in the vehicle if necessary. 3 Mount the Laser Shifters using the supplied hardware, making sure that each shifter is level to the road. Note: 1. Do not drill holes in the Laser Shifter itself. 2. Thoroughly investigate location before drilling any holes. 3. Keep all cables away from moving parts, and hot surfaces (radiator, hoses, etc.) 4. Do not splice cable. 5. Make certain that each Laser Shifter is level, and has a clear “view” of the road. Laser Shifter Cables 1 Route Laser Shifter cables to firewall, and secure with zip-ties (included). 2 Route both Shifter cables into the vehicle’s interior. If there is not a suitable opening, dril a 13/32" or 7/16" hole. 3 Pull cables through firewall, and plug connectors into Y-adapter. 4 Plug Y-adapter into jack marked “Front Laser/Shifter” on Interface. A A C E A C B B B B B D D D F