Linksys MGBLH1 - Gigabit LH Mini-GBIC SFP Transceiver Operation & User’s Manual

133 Limited Warranty Warranty Information Limited Warranty Linksys warrants this Linksys hardware product against defects in materials and workmanship under normal use for the Warranty Period, which begins on the date of purchase by the original end-user purchaser and lasts for the period specified for this product at www.linksys.com/ warranty. The internet URL address and the web pages referred to herein may be updated by Linksys from time to time; the version in effect at the date of purchase shall apply. This limited warranty i ...

35 Setup Tab—Summary Using the Web-based Utility for Configuration Subnet Mask—Enter the subnet mask of the currently configured IP address. Default Gateway—Enter the IP address of the Default Gateway. DNS Server—Enter the primary DNS Server information. You can click Restart DHCP to assign a new IP address using DHCP. Click the Save Settings button to save your changes or click Cancel Changes to discard the information. Setup Tab—Time The Time screen allows you to configure the time settings for the Switch. Simple Netwo ...

116 Admin Tab—User Authentication Using the Web-based Utility for Configuration * There are only Level 2, 5 and 6 event messages for the current firmware release System Logging The system allows you to enable or disable event logging, and specify which event levels are logged to RAM or flash memory. Severe error messages that are logged to flash memory are permanently stored in the Switch to assist in troubleshooting network problems. System Log Status—Enables/disables the logging of debug or error messages to the logging proc ...

16 Using the Console Interface for Configuration Using the Console Interface for Configuration Overview The SRW224G4P and the SRW248G4P Switches feature a menu-driven console interface for basic configuration of the Switch and management of your network. The Switches can be configured using CLI through the console interface or through a telnet connection. This chapter describes console interface configuration. Configuration can also be performed through the web utility, which is covered in the next chapter. Configuring the HyperTe ...

108 SNMP Tab Using the Web-based Utility for Configuration level and assigned to a group. The SNMPv3 group restricts users to a specific read, write, and notify view. User Name The name of user connecting to the SNMP agent. (Range: 1-32 characters) Local—Indicates a user accessing information only on the local switch. Remote—The engine identifier for the SNMP agent on the remote device where the remote user resides. Note that the remote engine identifier must be specified before you configure a remote user. The remote engine I ...

76 Security Tab—Authentication Servers Using the Web-based Utility for Configuration Remove—Click the Remove button to remove selected MAC addresses from the secure MAC address table. Security Tab—SSH Settings The Secure Shell (SSH) includes server/client applications that can provide remote management access to the Switch and act as a secure replacement for Telnet. When the client contacts the Switch through the SSH protocol, the Switch generates a public- key that the client uses along with a local user name and password f ...

38 Port Management Tab—Port Settings Using the Web-based Utility for Configuration MDI/MIDX—This is the MDI/MDIX status of the port. The MDI setting is used if the port is connected to an end station. The MDIX setting is used if the port is connected to a hub or another switch. Flow Control—This is the flow control status of the port. It is active when the port uses Full Duplex Mode. Type—Displays the port type. LAG—This indicates if the port is part of a LAG. Detail—The Detail button will open the Port Setting screen. ...