Memorex MB2190 Operation & User’s Manual

Specifications

Brand: Memorex
Category: Microcassette Recorder
Model: MB2190 (Operation & User’s Manual)
File Type: PDF
File Size: —
Pages: 13

Read Online

Read the Memorex MB2190 Operation & User’s Manual online using the built-in PDF viewer.

Text of the manual

Before operating this product,

please read these instructions completely. User’s Guide Micro Cassette Recorder MB2190 MB2190 O/M.QXD 3/31/03 3:07 PM Page 13

LOCATION OF CONTROLS

1. MIC (Microphone) Jack 2. VOLUME/VOX Mic Sensitivity Control 3. Microcassette Compartment 4. Tape Counter Reset Button 5. Tape Counter 6. REC/BATT Indicator 7. Speaker 8. PHONES (Headphones) Jack 9. VOX (Voice Activation) ON/OFF Switch 10. Built-in Microphone 11. PAUSE (ON/OFF) Switch 12. Record Button 13. Play Button 14. REW (REV)/F.F (CUE) Switch Button 15. Stop/Eject Button 16. Hand Strap Hole/Hand Strap* 17. CUE MARKER Button 18. TAPE SPEED (2.4/1.2) Switch 19. DC 3V Jack 20. Battery Compartment (Rear of Unit) + - * NOTE: The hand strap is attached and cannot be removed from the unit. MB2190 O/M.QXD 3/31/03 3:07 PM Page 1

Open the battery compartment and insert two (2) "AAA" size

batteries (not included) following the polarity diagram. Put the battery compartment cover back into place. NOTE: The REC/BATT indicator will brightly light during recording when batteries are fresh. When they are weak, the indicator will appear dim. BATTERY PRECAUTIONS Follow these precautions when using batteries in this device: 1. Use only the size and type of batteries specified. 2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. 3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones. 4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. 5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.) DC JACK To use this unit with an external AC adapter (not included) having 3V and a positive center pin, insert the AC adapter’s plug into the DC 3V jack on the unit. The batteries will be disconnected when the AC adapter is connected. + - + — + — MB2190 O/M.QXD 3/31/03 3:07 PM Page 2

Press the Stop/Eject button and

insert a microcassette tape with the side to be played facing you. Close the Cassette Compartment. 1 Slide the TAPE SPEED switch to the tape speed used when recorded. 2 TO PLAY A PRERECORDED MICROCASSETTE TAPE Press the Play button ❶ to start playback and adjust the VOLUME/VOX Mic Sensitivity control ❷ as desired. 1 2 3 To stop the tape before it reaches the end, press the Stop/Eject button. 4 OPERATION EARPHONE JACK For private listening, connect an earphone (not included) to this jack. The speaker is automatically disconnected when the earphone plug is inserted in the jack. MB2190 O/M.QXD 3/31/03 3:07 PM Page 3

To rapidly rewind a microcassette

tape in the Stop mode, slide the REW (REV)/F.F (CUE) switch ❶ to the REW (REV) position. Press the Stop/Eject button ❷ when you reached the desired position. 1 2 1 To rapidly review a microcassette tape, press the Play button ❶ and then slide and hold the REW (REV)/F.F (CUE) switch ❷ to the REW (REV) position. You will then hear the microcassette play at fast speed. Release the switch to resume normal playback. 2 1 2 TO FAST REWIND/REVIEW A MICROCASSETTE TAPE To rapidly forward a micro- cassette tape in the Stop mode, slide the REW (REV)/F.F (CUE) switch ❶ to the F.F (CUE) position. Press the Stop/Eject button ❷ when you reached the desired position. 1 2 1 To rapidly cue a microcassette tape, press the Play button ❶ and then slide and hold the REW (REV)/F.F (CUE) switch ❷ to the F.F (CUE) position. You will then hear the microcassette play at fast speed. Release the switch to resume normal playback. 2 1 2 TO FAST FORWARD/CUE A MICROCASSETTE TAPE OPERATION (CONTINUED) MB2190 O/M.QXD 3/31/03 3:07 PM Page 4

To pause Recording, Playback,

Rewind or Fast Forward, slide the PAUSE switch to the ON position. 1 To resume, slide back to the OFF position. 2 TO PAUSE A CASSETTE TAPE This unit can pause the microcassette while Recording, Playback, Rewind or Fast Forward TAPE SPEED SWITCH Set the one of the following positions: 2.4: NORMAL SPEED: Compatible with most single-speed microcassette recorders. This setting has the best sound quality. 1.2: LONGER RECORDING: This will allow double recording time, but the sound quality will not be as good as when in the normal speed mode. The tape counter is helpful in locating particular portions of the tape. The tape counter will count up or down when playing, recording, fast forwarding or rewinding a microcassette tape. 1 To reset the counter, press the Tape Counter Reset button; the counter will reset to “000” 2 TAPE COUNTER OPERATION (CONTINUED) MB2190 O/M.QXD 3/31/03 3:07 PM Page 5

Press the Stop/Eject button and

insert a microcassette tape with the side to be played facing you and the Erase Prevention Tab intact (see note below). Close the Cassette Compartment. 1 Slide the TAPE SPEED switch to the desired tape speed. 2 NORMAL RECORDING For constant recording, slide the VOX ON/OFF switch ❶ to the OFF position and press the Record button ❷ (the Play button will automatically depress) and the REC/BATT indicator will light. 2 1 3 Speak into the built-in microphone or insert a microphone into the MIC jack and speak into it in a normal tone of voice. 4 OPERATION (CONTINUED) This unit is capable of recording only when sound is heard. To use this feature, see the next page. For normal recording, follow the steps below. IMPORTANT NOTE: If you cannot press the Record button, then there is either no tape inserted, or the erase prevention tab has been removed. See page 9 for details. MB2190 O/M.QXD 3/31/03 3:07 PM Page 6

Press the Stop/Eject button and

insert a microcassette tape with the side to be played facing you. Close the Cassette Compartment. 1 For Voice Activated Recording, slide the VOX ON/OFF switch ❶ to the ON position and press the Record button ❷ (the Play button will automatically depress). 2 1 2 VOICE ACTIVATED (VOX) RECORDING Speak into the built-in micro- phone or insert a microphone into the MIC jack and speak into it in a normal tone of voice. Adjust the VOLUME/VOX Mic Sensitivity control until your voice activates the recorder (REC/BATT indicator will light). 3 NOTES: • The first few sounds activate the recorder and may not be recorded. • A variation in voice level during recording will not stop the unit; two seconds of silence is required to stop the recording. • For constant recording, see previous page. • When recording, the VOLUME/ VOX Mic Sensitivity control adjusts the microphone sensitivity. At 10, a soft sound will activate the recorder. At 0, a louder sound is required. OPERATION (CONTINUED) Voice activated recording will allow dictation only when you speak. When the unit detects a pause of a few seconds, it will temporarily stop recording until it detects sound again. MB2190 O/M.QXD 3/31/03 3:07 PM Page 7

While recording, press and hold

the CUE MARKER button for three seconds; a tone will then be recorded on the microcassette at that point. 1 When playing the message back, the cue marker tone will NOT be heard at the point it was recorded. Slide and hold the REW (REV)/F.F (CUE) switch to either the REW (REV) or the F.F (CUE) position during playing the message back; the unit will play back the recording at fast speed. You will be able to hear the Cue Marker humming sound when listening at fast speed. 2 CUE MARKER OPERATION (CONTINUED) The cue marker will allow you to record a tone on the microcassette for easy locating after you record. MB2190 O/M.QXD 3/31/03 3:07 PM Page 8

CARE AND MAINTENANCE

SAFEGUARD AGAINST ACCIDENTAL ERASURE When a new recording is made, any program material previously recorded is automatically erased and only the new recording remains. To safeguard valuable recordings from being erased accidentally, the cassette and the deck are equipped with a special device. On the cassette there is an erase prevention tab on each side. To prevent accidental erasing, break out these tabs with a screwdriver. If only one side of the tape is to be protected, break out the tab on the left side with the side desired facing you. To record on a tape in which the tab has been broken, place a piece of adhesive tape over that area. NOTE: When a tab is broken out, the record button cannot be depressed. CASSETTE TAPE RECOMMENDATIONS Standard tape lengths have 15 (C-30), 30 (C-60) and 45 (C-90) minutes of recording time on each side. Longer length tapes of 60 (C-120) minutes of recording time on each side are not recommended. Use only high quality tapes. If a problem develops, check the unit first with another cassette to determine if the problem is with the cassette, and not with the unit. If there is any slack in the tape in the cassette, it should be removed before inserting the cassette. Place a pencil in one of the hubs and rotate toward the outside of the cassette until all slack is taken up. MB2190 O/M.QXD 3/31/03 3:07 PM Page 9

CARE AND MAINTENANCE (CONTINUED)

CLEANING Clean the tape head, capstan and pinch roller using a cotton swab slightly moistened with alcohol. Avoid scratching the head surface. To clean the unit housing, use a soft cloth slightly dampened with water and wipe dry. CAUTION: Never use chemicals such as benzene or paint thinner for cleaning, otherwise the case may be deformed or discolored. Traffic Safety • Do not use while operating a motorized vehicle. It may create a traffic hazard and is illegal in many areas. • Even if your earphone is an open air type designed to let you hear outside sounds, do not turn the volume up so high that you cannot hear what is around you. • Use extreme caution or temporarily discontinue use in potentially hazardous situations. MB2190 O/M.QXD 3/31/03 3:07 PM Page 10

Tape Speed. . . . . . . . . . . . . . . . . . . . . 2.4cm/sec or 1.2cm/sec

Frequency Response. . . . . . . . . . . . . . . . . . . . . . . 250-4500Hz Speaker. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25mm (8 Ohm) Power Source . . . . 3V, “AAA” size x 2 batteries (Not Included) Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . 119 x 65 x 23 mm Weight . . . . . . . . . . . . . . . . . . . . . . . . . 140g (without batteries) Specifications are subject to change without notice. 11 FOR ADDITIONAL SET-UP OR OPERATING ASSISTANCE, PLEASE VISIT OUR WEBSITE AT WWW.MEMOREXELECTRONICS.COM OR CONTACT CUSTOMER SERVICE AT 1-800-919-3647 PLEASE KEEP ALL PACKAGING MATERIAL FOR AT LEAST 90 DAYS IN CASE YOU NEED TO RETURN THIS PRODUCT TO YOUR PLACE OF PURCHASE OR MEMOREX. FOR PARTS AND ACCESSORIES, CONTACT FOX INTERNATIONAL AT 1-800-321-6993. MB2190 O/M.QXD 3/31/03 3:07 PM Page 11

Printed in Hong Kong

Visit our website at www.memorexelectronics.com MB2190 O/M.QXD 3/31/03 3:07 PM Page 12

Other Microcassette Recorder Manuals