Oki T400 Installation Manual

(USED ON DIRECT THERMAL AND THERMAL TRANSFER UNITS) STEP PROCEDURE �� ����������������������������������������������������� �� ����������������������������� ...

LEFT END OF PLATEN IN SUPPORT YOKE RIGHT END OF PLATEN IN SUPPORT YOKE GENTLY LIFT PLATEN FROM THE RIGHT SIDE OF THE SUPPORT FRAME AND GEARS ON THE LEFT Direct Thermal Unit ...

REMOVE BEARINGS, GEAR AND "C" RINGS INSTALL DISPENSER PLATE AND REPLACE BEARINGS, GEAR AND "C" RINGS INSTALL DISPENSER PLATE AFTER REMOVING EXISTING TEAR BAR REMOVE "C" RINGS BOTH ENDS Direct Thermal Unit ...

LINE UP EDGE OF GUIDE SHEET AND NOTCH PRESS DOWN TO ATTACH TO FRONT DOOR PANEL PEEL BACKING PAPER FROM GUIDE SHEET STEP PROCEDURE �� �������������������������������������������������������������� ...

PLUG CONNECTOR INTO CN13 RIGHT SIDE LOCATING PIN SECURE DISPENSER WITH (2) SCREWS LINE UP HOLES WITH LOCATING PINS Direct Thermal Unit ...

STEP PROCEDURE ����������������������������������������������������������������������� �������������������������������� ...

Thermal Transfer Unit: REMOVE SCREW TO DETACH LEVER FROM PRINT HEAD AND RIBBON ASSEMBLY INSERT A FLAT BLADE SCREWDRIVER UNDER THIS BRACKET (OR BY OTHER MEANS) TO DISENGAGE THIS END OF THE RIBBON ASSEMBLY FROM THE PRINT HEAD POSITIONING PIN ON BACKSIDE OF BRACKET FITS INTO HOLE ON PRINT HEAD PULL BRACKET FORWARD TO RELEASE ...

For Thermal Transfer Unit: SLIDE THE RIBBON ASSEMBLY BACKWARD TO DISENGAGE THIS END FROM THE PRINT HEAD POSITIONING PIN ON THE UNDERSIDE OF THE RIBBON ASSEMBLY FITS INTO HOLE ON PRINT HEAD RECONNECT IF DISENGAGED ...

IN SUPPORT YOKE RIGHT END OF PLATEN IN SUPPORT YOKE GENTLY LIFT PLATEN FROM THE RIGHT SIDE OF THE SUPPORT FRAME AND GEARS ON THE LEFT Installing the Dispenser Kit For Thermal Transfer Unit: ...

AND "C" RINGS INSTALL DISPENSER PLATE AND REPLACE BEARINGS, GEAR AND "C" RINGS INSTALL DISPENSER PLATE AFTER REMOVING EXISTING TEAR BAR REMOVE "C" RINGS BOTH ENDS Installing the Dispenser Kit For Thermal Transfer Unit: ...