NetComm NP504 Quick Start Manual
Read Online
Read the NetComm NP504 Quick Start Manual online using the built-in PDF viewer.
Text of the manual
NETCOMM POWERLINE™ SERIES
500Mbps Powerline Adapters
with AC Pass-through
NP504 Quick Start Guide
Setting Up Your
Powerline Adapters
Using one of the supplied Ethernet cables connect one end into the LAN
Ethernet port of your modem/router.
Connect the other end of the same cable into one of the Powerline Adapters.
Connect the Powerline Adapter to a power point near your modem/router.*
*NOTE: For best performance plug your Powerline Adapters directly into the wall. Do not connect to a powerboard.
Connect one end of the other supplied Ethernet cable into the Ethernet port
of any device you want to connect to the Internet (PC, set-top box, gaming
console, PVR, blu-ray player etc).
Connect the other end of the cable into the second Powerline Adapter.
Connect the Powerline Adapter to a power point near your device.
NOTE: For best performance plug your Powerline Adapters directly into the wall. Do not connect to a powerboard.
At this point, you can plug another electrical appliance into the Powerline
Adapters AC pass-through if you wish to do so.
Both Adapters will take a short time to find each other. Once they have, all three
lights on both Adapters should be on.
NOTE: For best performance connect other electrical devices to the AC Pass-through socket rather than connecting the
Powerline Adapter to a powerboard. If possible, also avoid plugging other electrical devices into the socket next
to the Powerline Adapter to ensure your network performs to its full potential.
TV
PC
What can the LEDs tell me?
The powerline LED
changes colour depending on the speed of your data transfer.
- Fastest
- Faster
- Fast
LED Off - The adapter is not paired or wall socket not turned on.
For any technical support enquiries please contact the
NetComm technical support team on
WWW.NETCOMM.COM.AU/CONTACT-US
to fill out an online enquiry or alternatively call
(02)9424 2059
My Powerline Adapters Will Not Connect To Each Other
Hold down the Simple Connect button on the first device for 15 seconds, or until
the LEDs flash, then hold the Simple Connect on the second device for 3 seconds
and finally hold the Simple Connect button on the first device for 3 seconds.
The network password has now been reset and both adapters will be able to
communicate with each other.
To make this process easier it is recommended that both Adapters are connected to
a powerpoint near each other or in the same room.
YML504_REV1
