Pico Macom PFT-10 Specifications

Ph: 858-546-5050 Toll Free: 800-421-6511 Fax: 858-546-5051 www.picomacom.com Fiber Optic Series PICO MACOM Rev. 9/07 • Wide bandwidth, 54~860MHz, high-performance single-mode 1310nm optical fiber transmitter. • Supports analog and QAM digital applications. • Wide range laser options, from 6dBm to 14dBm (4mW to 26mW), for multiple broadband applications. • Optical power monitoring of input RF and laser status. • RS232 port. Features • Manual or automatic gain controls RF input level. • Automatic gain controlled input allows unit to maintain the same optical output with varying inputs without distortion. • Input voltage between 90-260Vac. • Unit can be used for NTSC and PAL systems. • Front panel RF test port -20dB. • Low power consumption. T he Pico Macom PFT Series of optical transmitters is available in nine output power levels, from 6 to 14dBm, allowing flexibil- ity in numerous CATV applications. Each unit takes various combinations of input modulated RF signals and converts them to light for distribution to nodes. With an optical wavelength of 1310nm and a bandwidth of 54~860MHz, the transmitter supports transmission of NTSC and QAM RF signals over a single-mode optical fiber. The PFT Series optical fiber transmitters are 19˝ wide and rack mounted with a height of 1RU. PFTSeries 1310nm Optical Transmitters

6260 Sequence Drive San Diego, CA 92121 Ph: 858-546-5050 Toll Free: 800-421-6511 Fax: 858-546-5051 Rev. 9/07 www.picomacom.com 2 Optical Output Power in dBm: 6, 7, 8, 9, 10, 11, 12, 13, 14 dBm Optical Wavelength: 1310nm Laser Type: DFB Optical Connector Type: SC/APC (FC/APC Optional) RF Frequency Range: 50~860 MHz RF Input Level Range: +15 to 20dBmV RF Input Impedance: 75Ω In-Band Flatness: ±1dB Input Return Loss: >15dB Carrier-to-Noise (CNR)*: >50dB Composite Second Order (CSO)*: >60dB Composite Triple Beat(CTB)*: >65dB AGC Control Range: ±5dB MGC Control Range: ±5dB Power Supply Range: 90-264 Vac Power Consumption (typical): 30 watts Operating Temperature: 0° to 50°C Storage Temperature: -20° to +65°C Relative Humidity: <10% Dimensions: 19˝ W x 13˝ D x 1.75˝ H Weight: 9.15 lbs. Specifications PFT - 6 (6dBm or 4mW) - 1310nm Optical Transmitter PFT - 7 (7dBm or 5mW) - 1310nm Optical Transmitter PFT - 8 (8dBm or 7mW) - 1310nm Optical Transmitter PFT - 9 (9dBm or 8mW) - 1310nm Optical Transmitter PFT - 10 (10dBm or 10mW) - 1310nm Optical Transmitter PFT - 11 (11dBm or 14mW) - 1310nm Optical Transmitter PFT - 12 (12dBm or 16mW) - 1310nm Optical Transmitter PFT - 13 (13dBm or 20mW) - 1310nm Optical Transmitter PFT - 14 (14dBm or 26mW) - 1310nm Optical Transmitter 90-240VAC 47-63HZ REMOTE CONTROL RF IN OPTICAL OUT Rear View Front View Ordering Information * Test results are typical and were performed at our San Diego test center using an 80 channel NTSC Matrix generator as the RF source, appropriate optical loss budget for the 1310nm transmitter being tested and optical receiver input level of -1dBm. 1310 nm OPTICAL TRANSMITTER STATUS STATUS RF AGC ON/OFF RF AGC ON/OFF MGC ADJUST LASER LASER ON/OFF LASER ON/OFF RF AGC MGC RF RF RF TEST PORT PFT-1310mn Optical Transmitter