Pioneer GEX-AIRWARE1 Manual 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. The Pioneer XM AirWare Satellite Radio Receiver incorporates an FM transmitter and is therefore classified as an intentional transmitter. Changes or modifications to the unit not expressly approved by Pioneer can void your authority to operate this equipment. Important: The FCC and FAA have not certified the Pioneer XM AirWare Satellite Radio Receiver for use in any aircraft (neither portable nor permanent installation). Therefore, Pioneer cannot support this type of application or installation. PIONEER ELECTRONICS (USA) INC. CUSTOMER SUPPORT DIVISION P.O. Box 1760 Long Beach, CA 90801 800-421-1404 Printed on Recycled Paper 2005 ©Pioneer Corporation. All rights reserved. AirWare is a registered trademark of Pioneer Corporation. The XM name, XM2Go, TuneSelect, and related logos are trademarks of XM Satellite Radio Inc. AirWare® receiver Satellite Radio Receiver – Quick Guide GEX-AIRWARE1 Warning: This manual contains important safety and operating information. Please read and follow the instructions in this manual. Failure to do so could result in personal injury, death, and/or damage to your AirWare receiver, accessories, and/or to your vehicle or other property. headphones vehicle antenna rechargeable lithium ion battery cassette adaptor vehicle docking station remote control belt clip/stand cleaning kit flush mount vehicle power adaptor swivel mount (with extra adhesive pad) vent mount audio cable home antenna protective case home docking station home power adaptor gd_eng_fin4.r5.qxd 4/14/05 5:56 PM Page 1

Install the battery Be sure to charge your battery for at least 3 hours on the home stand before use. Set up Assemble your AirWare® and its home docking station as shown. Connect to stereo Plug the AC adaptor into an outlet. Connect the home antenna and connect the line out to either your home stereo or powered (PC type) speakers. 1 2 3 4 display – backlit high- resolution LCD display 2go button – store up to five hours of XM programming using the “MY XM” Time-shifting Memory Mode arrow buttons – cycle through channel categories (“LIVE”); skip to previous or next song (“MY XM”) mode button – switch between “LIVE” XM and “MY XM” Time-shifting Memory Mode preset/direct button – select between direct channel entry or up to 30 presets number keys – enter a channel directly or select your favorite presets power button – press and hold to turn your AirWare on and off dial – rotate to highlight a channel or menu option; push in to make selection, or press and hold for TuneSelect volume buttons – raise or lower volume only when headphones are plugged in menu button – access advanced features and configuration options memory button – save and recall song information such as artist and song title mute/pause/lock button – press once to mute audio (“LIVE”) or pause playback (“MY XM”); press and hold to lock or unlock your AirWare controls display button – change the appearance of the display, including access to different modes that display stocks or sports scores IR lens – aim your remote control here Controls Turn on your AirWare by pressing the power button. You should be able to hear channel 1, the XM Preview Channel, through your head phones or attached stereo/speakers. Before you begin, take a moment to familiarize yourself with your AirWare’s controls. Most basic functions can be accessed using the front panel buttons and the dial. More advanced features are accessed using the “menu” button and the dial. 5 Aiming the home antenna If you do not hear channel 1, the XM Preview Channel, and the screen displays “NO SIGNAL,” try moving your AirWare‘s antenna to another location. Make sure the antenna points south outdoors or through a window. Complete instructions, including an optional activation setup in a vehicle, the availability of accessories designed to improve your signal reception, and more useful information and tips about your AirWare can be found in your AirWare User Guide. Your AirWare can help you aim the home antenna to pull in the strongest signal. 1. Using the “menu” button and dial, choose “Antenna Aiming.” 2. Slowly turn and tilt the antenna. The signal bars on the display will change. Find the position that gives at least two bars on either “satellite” or “terrestrial.” 3. When you’ve found the best position, press the “menu” button to return to normal operation. Note: Satellite radio reception depends on the ability of the antenna to receive/record a signal. The signal may not be available in buildings or if obstructed (e.g. by mountains, trees, bridges, etc.). set... Activate and explore Turn the dial to highlight channel 0, and press the dial in to select it. You should see an 8-character XM Radio ID in the display. (The XM Radio ID should also be on your AirWare’s package and under the battery.) Write the ID here: XM subscription required for reception of XM service. Not available in Alaska or Hawaii. Activate your XM Satellite Radioservice by contacting XM at http://activate.xmradio.com or by calling 1.800.XM.RADIO (1.800.967.2346). You will need the XM Radio ID and a major credit card. XM will send a signal from the satellites to activate the full channel lineup. Activation normally takes 10 to 15 minutes, but during peak busy periods, you may need to keep your AirWare on longer to complete the activation process. Rotate the dial to preview a list of channels. When you find one you’re interested in, press the dial in to tune to that channel! If you want to tune to a channel and know its channel number, you can use the number keys. Press the “pre/dir” button until “DIRECT” flashes in the display. Press the number keys corresponding to the channel number, e.g., “4” followed by “5” for channel 45. XM’s channels are organized into categories such as “Rock,” “Country,” “News,” and “Sports.” Press the “ ” and “ ” buttons to explore these categories; rotate the dial to view the channels within each category. lock indicator channel selection mode – direct entry or preset banks A, B, or C signal strength – 0 to 3 bars channel name additional info – volume/playback bars, Stock Ticker, and Info Extras The XM Radio ID does not use the letters I, O, S, and F. go! Charge the battery and store some music 2go: Store and play back with a single button Your AirWare lets you store up to five hours of programming and play it back at a later time. Listen to XM wherever you are, including in a tunnel, subway, or anywhere satellite coverage may be limited. While the battery is charging in the home docking station, try storing some XM programming from XM’s lineup of over 130 channels! TO STORE: 1. Turn on your AirWare and select a channel. 2. Press the “2go” button. To prevent you from accidentally storing over a previously stored program, your AirWare will ask you to confirm. Press the “2go” button again. The center of the top line of your AirWare’s screen switches from “LIVE” to “REC.” 3. To stop storing and continue with live programming, press the “2go” button again. The display reverts to “LIVE.” TO PLAY BACK: 1. Press the mode button. Your AirWare switches from “LIVE” to “MY XM”, and will begin to play back from the beginning or where you last stopped or paused. 2. “MY XM” holds up to five hours of programming. Press either the “ “ or “ “ button to skip to the previous or to the next song. 3. You can also rotate the dial to view a list of the stored artists and songs. Simply highlight an artist using the dial; the artist, song title, and other useful information will scroll by. Then press the dial in to listen to it. go further... Advanced features & additional info Check out the User Guide for advanced features, troubleshooting guidelines, and additional information. listening mode – show current listening mode (“LIVE” or “MY XM”) alarm indicator alarm indicator battery level and charging status clock channel number artist name song or program title 2 1 k_gd_eng_fin4.r5.qxd 4/14/05 5:56 PM Page 2