Elpro Technologies 2080E-T Installation Manual

©2013 Cooper Bussmann www.cooperbussmann.com/wirelessresources 10/16 Page 1 of 2 Version 1.0 Power Input and Fault Alarm Contact Wire Gauge: 12–24 AWG RJ-45. Port Connection: Use four twisted pair Cat 5, 5e, or 6 cables less than 100 meters long. NOTE This equipment is suitable for use in Class I, Division 2, Groups A, B, C, and D or non-hazardous locations only. WARNING – EXPLOSION HAZARD! • Do not disconnect equipment while the circuit is live unless the area is known to be free of ignitable concentrations. • Do not disconnect equipment unless power has been removed or the area is know to be non-hazardous. • Substitution of any components may impair suitability for Class I, Division 2. • The area must be known to be non-hazardous before servicing or replacing the unit and before installing the unit. WARNING Exposure to some chemicals may degrade the sealing properties of materials used in the sealed relay device. It is recommended to inspect the sealed relay device periodically and to check for any degradation of the materials and replace the complete product (not the sealed device) if any degradation is found. Terminal Block for Power 1, Power 2 and Fault Alarm Contact RS-232 Console Port 10/100 TX RJ-45 Ethernet Ports (8) 1. Insert DC power wires into the contacts for Power Supply 1 and 2. 2. Tighten the terminal screws to ensure that the wires do not come loose. Power Supply 2* Power Supply 1 *Power Supply 2 is used for redundant supplies. Surge EARTH POWER SUPPLY WIRING DC Power Input Range: 12VDC–48VDC FAULT CONTACT WIRING 2080E-T 2080E-T Surge EARTH FAULT ALARM CONTACT 1A@24V N/C Contact Contact will open when a fault occurs DC DC

10/16 Page 2 of 2 Version 1.0 ©2013 Cooper Bussmann www.cooperbussmann.com/wirelessresources Pin Connections DB-9 Female RJ-45 Pin - 2 2 - Orange Pin - 3 3 - Green/White Pin - 5 5 - Blue/White Other Pins - NC Other Pins - NC RS-232 Connection Setting: 9600 baud, 8 bits, no parity, 1 stop bit, no flow control RS-232 CONSOLE PORT CABLE DIN-RAIL MOUNTING 1. Insert the top of the DIN rail clip onto the DIN rail. 2. Press the 2080E-T onto the DIN rail until it clicks into place. 3. Check that the module is securely attached to the DIN rail. 4. To remove the 2080E-T from the DIN rail, press down on the rear top of the module and swing the bottom of the module forward. WALL MOUNT PLATE MOUNTING 1. Remove the DIN rail from the 2080E-T by loosening the three screws. 2. Place the wall mount plates on the rear panel of the 2080E-T. 3. Use six screws to screw the wall mount plates onto the 2080E-T. 4. Use the hook holes at the corners of the wall mount plates to mount the 2080E-T on the wall. 5. To remove the 2080E-T from the wall, reverse these steps. RS-232 DB-9 Female RJ-45