Digimerge DPV14W Instruction Manual

WARNINGS AND CAUTIONS: CAUTION: CAUTION CAUTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER(OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. EXPLANATION OF GRAPHICAL SYMBOLS The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. Should any liquid or solid object fall into the cabinet, unplug the unit and have it checked by the qualified personnel before operating it any further. Unplug the unit from the wall oulet if it is not going to be used for several days or more. To disconnect the cord, pull it out by the plug. Never pull the cord itself. Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on surfaces (rugs, blankets, etc.) or near materials(curtains, draperies) that may block the ventilation holes. Height and vertical linearity controls located at the rear panel are for special adjustments by qualified personnel only. Do not install the unit in an extremely hot or humid place or in a place subject to excessive dust, mechanical vibration. The unit is not designed to be waterproof. Exposure to rain or water may damage the unit. Clean the unit with a slightly damp soft cloth. Use a mild household detergent. Never use strong solvents such as thinner or benzine as they might damage the finish of the unit. Retain the original carton and packing materials for safe transport of this unit in the future. Safety ----------------------------------------- Installation ----------------------------------- Cleaning -------------------------------------- PRECAUTIONS TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. DO NOT INSERT ANY METALLIC OBJECTS THROUGH THE VENTILATION GRILLS OR OTHER OPENINGS ON THE EQUIPMENT.

AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS A DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE WHEN THE EQUIPMENT IS OPERATED IN A COMMERCIAL ENVIRONMENT. THIS EQUIPMENT GENERATES, USES, AND CAN RADIATE RADIO FREQUENCY ENERGY AND IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTION MANUAL, MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS. OPERATION OF THIS EQUIPMENT IN A RESIDENTIAL AREA IS LIKELY TO CAUSE HARMFUL INTERFERENCE IN WHICH CASE THE USER WILL BE REQUIRED TO CORRECT THE INTERFERENCE AT HIS OWN EXPENSE. CAUTION : CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. THIS CLASS A DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003. NORME NMB-003 DU CANADA. WARNING This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. CE COMPLIANCE STATEMENT FCC COMPLIANCE STATEMENT - iii -

7 -2 Do NOT use power source other than 17 that specified. 17. CAUTION-these servicing instructions are for use by qualified service personnel only. to reduce the risk of electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. 5. ACCESSORIES - iv -

The camera provides high-quality images using PIXIM DPS(Digital Pixel System) 1/3" Wide Dynamic Range Sensor. Features: High resolution and high performance 1/3" CMOS(PIXIM DPS) technology Wide Dynamic Range(WDR) Excellent picture quality Minimal blooming Zero smear Built-in NTSC/PAL video encoder 540 lines(Color) of resolution 0.5 Lux(Color) @ F1.2 Sensitivity Upto 1/22,000sec electronic shutter at f/1.2 OSD (On Screen Display) Auto white balance modes Day & Night (Auto / OFF) AGC (Auto Gain Control) VIDEO OUT(BNC) Internal/AC line lock Operates in 12VDC or 24VAC Use Certified / Listed Class 2 power supply only. 2.8-12mm Day/Night A/I Varifocal Lens F1.4 Camera Mount : camera mount directily to the wall or ceiling Test Monitor Output INTRODUCTION IMPORTANT : The user of this camera is responsible for checking and complying with local, state, and federal laws and statutes concerning the recording and monitoring of audio signals. PACKAGE CONTENTS The package contains the following. Camera in Housing 1 Instruction Manual (This Document) 1 Accessory Kit for Installing 1 1 Drilling guide label

intact in the front portion. (Fig. 1) 2. Drill the mounting location, using the bottom of the housing as a Drilling guide label. (Fig. 2) 3. Attach the housing to the ceiling using suitable fasteners, M6x35 tapping screws are supplied only use if they are suitable. (Fig. 2) 4. Closing the housing using the loosen torx screws. (Fig. 3) Torx screws M5x10 (4x) Figure 1 Figure 2 Torx screws M5x10 (4x) Seal around the housing base tightly using the silicon rubber - 2 - 1. Lens : 2.8-12mm D&N A/I Vari-focal lens for wide area monitoring. 2. Power : 24V AC input / 12V DC input power source from a DC 12V or AC 24V ac +/-10% 60/50Hz +/-1Hz Use Certified/Listed Class 2 power supply transformer only. *If using DC 12V power adaptor, use a power supply capable of supplying 6 Watts. 3. Video : BNC connector used to connect the camera to a monitor, switcher, etc. 1 3 2 1 3 2 CAMERA CONNECTIONS

1 2 3 4 5 The housing can also be mounted on a 4s electrical box. MOUNTING HOUSING TO AN ELECTRICAL BACK BOX Electrical box Torx screws UNC 8-32 x 0.75 Rubber Washers(4x) 1 2 3 4 5 Figure 3 CEILING Drilling Guide Label Plastic Anchor(4x) Rubber Washers(4x) Mounting Screw M6X35(4x) - 3 - Note: Electrical box is not supplied. 6 6

PUSH AWB CONFIRM > Save AWB & ALL Chngs. CANCEL ''' WARNING ''' will ALL User be written to ROM properties LINELOCK MENU V PHASE DAY/NIGHT THRESHOLD SETUP IN OUT

Fixed mount Day & Night Lens 2-Pin wire / 2-Pin terminal block f=2.8~12mm F1.4, Varifocal DC auto iris ICR 0.5 Lux(Color), 0.01 Lux(B/W) @ F1.2, 50IRE o o o o ] -10 C ~ +50 C [14 F ~ 122 F PRESETS Default / Indoor / Outdoor ATW Normal / ATW Xtnd / AWB / WD Normal Normal / AUTO / off

Shipping: Unit: mm 0.1 in. (2.5mm thick), impact-resistant P.C (LEXAN) 3.93 in. (10cm) diameter One 1" opening holes 1.54 lb. (0.7kg) 2.11 lb. (0.96 kg) 146.3 PF 3/4" TAP o 45 o 45 1.0 12 113.7 . 4- 6 4 50302660A 540TV Lines WDR Super High Resolution Day & Night Color Camera