GE Interlogix Simon Operation & User’s Manual

3 How to Use Your Control Panel The panel interface consists of four rows of buttons. Note It may be necessary to enter an access code to arm your system. Check with your installer to see if this feature is enabled. • HOME SECURITY • CODE • HOME CONTROL • EMERGENCY HOME SECURITY The Home Security buttons are used to arm and disarm doors, windows and motion sen- sors in your system. The System Status button is used to give information on system activity. Arm Turn on intrusion/burglary protection for your system. You can arm door/window sen- sors, motion sensors or ...

26 • Escape fast! (Do not stop to pack.) • Use a different escape route if closed doors feel hot to the touch. • Crawl and hold your breath as much as possible to help reduce smoke inhalation during your escape. • Meet at a designated outdoor location. • Emphasize that no one should return to the premises if there is a fire. • Notify the fire department from a neighbor’s phone. • Emphasize that no one should enter the premises if they hear sirens in the house. • If you arrive at the premises and hear sirens, do not enter. Call for emergency assistance fr ...

2 Outdoor Motion Sensors detect motion in a protected outdoor area. When motion is detected, the system may respond by sounding chimes or turning on outside lights. These sensors are not used for intrusion detection. Door/Window Sensors detect the opening of a door or window. Smoke Sensors detect smoke and a significant rise in temperature. They have a built in siren that sounds when smoke or a significant rise in temperature is detected. Freeze Sensors detect furnace failure. If the inside temperature drops below 41°F, the sensor will notify the panel. The sensor will s ...

13 1. System must be disarmed. Open the Panel Cover by pressing the plastic latch on the top of the panel. When you open the cover you will immediately be prompted by the panel voice to use the numbered keys to enter your ID. Note The Master access code is 1-2-3-4 when the panel is shipped. You should change your Master Access Code after your system is installed (see “Access Code”). 2. Enter the Master Access Code. 3. The system voice will prompt you to begin with the START MENU. The START MENU includes the following buttons: • Add • Delete • Cancel • Test • ...