Zte CruiseConnect Quick Start Manual

Appearance The following figure is for your reference only. 1. Reset hole 2. micro-SIM card slot 3. Restart key 4. LED 1 5. LED 2 6. OBD interface

Indicator lights Indicator Status Description LED 1(Power) Green blinking Powered by the internal battery. Green solid Powered by the vehicle battery. LED 2(Signal) Red solid Turn on but not register. Green solid Registered to the 4G network. Green blinking Connected to the 4G LTE network and data is being transferred. NOTE: The charging temperature should be lower than 45℃. .

1. Use the tray eject tool to take out the card tray. 2. Put the micro-SIM card into the card tray and slip it into the card slot. WARNING! To avoid damage to the device, please do not use other kinds of SIM cards, and do not use a non-standard micro-SIM card cut from a SIM card. You can get the standard micro-SIM card from your service provider. 3. Close the micro-SIM card cover.

1. Make sure your vehicle is parked outside in a safe location and the engine is turned off. 2. Find your vehicle’s On-Board Diagnostics (OBD II) connector port. NOTES:  The OBD II port is usually located under the driver’s dash side of your car, often within 18 inches of the steering wheel (as 1 to 8 shown in the following picture).  Write down the Wi-Fi SSID and Password information.  If you’re having trouble locating your car’s OBD II port, reference your vehicle’s manual. 3. Plug your device into the vehicle’s OBD II port.

1. Start the engine. 2. Check the device indicator after 2-5 minutes. 3. Green LED 2 indicates your device is activated successfully.

1. Download the “CruiseConnect” app available in iTunes or Google Play. 2. Click on ‘Sign Up’ on the main screen of the app. 3. Enter your name, Cell Number, Email address and Continue.

authorization code to confirm your phone number is valid. Enter this code to continue. 5. Scan the QR code located on a reference card in the device box.

seconds. 7. Once completed you will receive a success message and hit continue to enter into the application.

1. Find your OBD II device's network name in your Wi-Fi device's list of available wireless networks. 2. Select the Wi-Fi name (SSID) of your OBD II device. (You can check the label on the device to get the default Wi-Fi SSID and password.) 3. Input the password, and then tap Connect.

All rights reserved. No part of this publication may be quoted, reproduced, translated or used in any form or by any means, electronic or mechanical, including photocopying and microfilm, without the prior written permission of ZTE Corporation. Notice This guide is published by ZTE Corporation. We reserve the right to make modifications on print errors or update specifications without prior notice. Every effort has been made in the preparation of this guide to ensure accuracy of the contents, but all statements, information, and recommendations in this guide do not constitute a warranty of any kind, expressed or implied.

Please visit the ZTE official website (at www.zteusa.com) for more information on self-service and supported product models. Information on the website takes precedence. Disclaimer 4G LTE is not available in all areas. See uscellular.com/4G for complete coverage details. 4G LTE service provided through King Street Wireless, a partner of U.S. Cellular. LTE is a trademark of ETSI. ZTE Corporation expressly disclaims any liability for faults and damages caused by unauthorized modifications of the software. Images and screenshots used in this guide may differ from the actual product. Content in this guide may differ from the actual product or software. Trademarks ZTE and the ZTE logos are trademarks of ZTE Corporation.

State of California could cause cancer, birth defects or other reproductive harm. Version No.: R1.5 Edition Time: Sept 25, 2017 Manual No.: