Winmate M101B Quick Installation Manual

You can purchase digital signage system, including display and OPS module from Winmate. This section describes Winmate model combination, and includes some notes on each case. Case I PC Mode Purchase All-in-one (touch monitor and OPS module) from Winmate Diagram: Note: 1. USB touch: in this case USB touch signal is set to go through internal OPS connector. 2. Power: when your signal comes from OPS module , make sure the power managment settings default is "shut down"(refer to page 10) Case II Monitor Mode Purchase only touch monitor from Winmate Diagram: N ...

3 Advisory Conventions Four types of advisories are used throughout the user guide to provide helpful information or to alert you to the potential for hardware damage or personal injury. These are Notes, Important, Cautions, and Warnings. The following is an example of each type of advisory. NOTE: A note is used to emphasize helpful information IMPORTANT: An important note indicates information that is important for you to know. CAUTION A Caution alert indicates potential damage to hardware ...

5 Introduction Open Pluggable Specification (OPS) enables easy integration of a digital signage computing system or a pluggable module into the display panel. This quick start guide tells you step-by-step instruction on how to install OPS module to the display. You will find instructions for the following procedures:  Unpacking  Touch and Power Connection Scenario  OPS Module Installation  Display Input Signal Settings  Powering ON/ OFF  Power Management Settings  Sealin ...

This section describes the OPS module installation procedures. OPS module slot is located on the rear side of the display. Hardware installation steps: 1. Disconnect the AC power source from the Display, and make sure the system is powered OFF when you insert the OPS module. 2. Matchthe OPS module slot position with the Display. 3. Insert the OPS module to the slot on the rear side of the Display. 4. Fasten two Phillips M3x5 mm round head screws to fix OPS module to the Display. Refer to the picture below for hardware installation illustration. WARNING! Always make su ...

9 Display Input Signal Settings Remote Control Layout 1 [POWER] button Press to switch on the display from standby mode. Press again to turn it off and back into standby mode. 2 [SMART] button Press to activate Smart Menu. Press [ ] or [ ] button to select menu options. Press [SET] button to confirm and exit the selection.  Standard: Used for normal images (factory setting).  Highbright: Used for moving image such as Video.  sRGB: Used for text based images. 3 [PIP] (Picture-in-pict ...

9 Display Input Signal Settings Remote Control Layout 1 [POWER] button Press to switch on the display from standby mode. Press again to turn it off and back into standby mode. 2 [SMART] button Press to activate Smart Menu. Press [ ] or [ ] button to select menu options. Press [SET] button to confirm and exit the selection.  Standard: Used for normal images (factory setting).  Highbright: Used for moving image such as Video.  sRGB: Used for text based images. 3 [PIP] (Picture-in-pict ...