Serialio BlueSnapXP Operation & User’s Manual

27 Cedar Park, TX, USA • (512) 994-3630 • [email protected] www.serialio.com SF,1 Set Factory Defaults. SI, - Inquiry Scan Window. Sets amount of time device spends enabling inquiry scan (discoverability) . Minimum value is 0x0012, corresponding to about 1% duty cycle. Inquiry interval is fixed at 0x1000, so time spent in inquiry is 0x12/0x1000 by default. Maximum value is 0x1000, set to 0x0000 to disable inquiry scan and make device non- discoverable. Default value is 0x0200. SJ, ...

27 Cedar Park, TX, USA • (512) 994-3630 • [email protected] www.serialio.com From your PC desktop, click My Bluetooth Places, go to the Bluetooth Device configuration (or Advanced Configuration) drop down menu, click on the client applications tab, Select the Bluetooth serial port application name, and click on the properties button, if “secure connection”, or “authentication”, or “encryption” is checked, un check it. Changing the clients COM port: Widcomm stack, the most common stack ...

27 Cedar Park, TX, USA • (512) 994-3630 • [email protected] www.serialio.com NOTE: for the purpose of configuration above, the swithes/IO pins are sampled ONLY at power up time, (during the first 500milliseconds) so they can be used for other functions once the device is in operation. The exception is the factory reset switch/PIO, which once enabled, can be toggled at any time after powerup, a total of 3 transitions will cause the factory reset to occur. 4. Command Reference The commands a ...

27 Cedar Park, TX, USA • (512) 994-3630 • [email protected] www.serialio.com Below are Internal Jumper options for BlueSnap Standard (Male) and BlueSnap 9V (Male) (internal jumpers for Female DB9 versions are different, see the following page) DCE 3 Wire Factory Default (CTS shorted to RTS), DTE (Like a PC) RX=2, TX=3, RTS=7, CTS=8 Remove 3rd, 4th jumpers and one jumper in position 5 DCE (Like a Modem), RX=3, TX=2, RTS=8, CTS=7 ...

27 Cedar Park, TX, USA • (512) 994-3630 • [email protected] www.serialio.com From your PC desktop, click My Bluetooth Places, go to the Bluetooth Device configuration (or Advanced Configuration) drop down menu, click on the client applications tab, Select the Bluetooth serial port application name, and click on the properties button, if “secure connection”, or “authentication”, or “encryption” is checked, un check it. Changing the clients COM port: Widcomm stack, the most common stack ...

27 Cedar Park, TX, USA • (512) 994-3630 • [email protected] www.serialio.com line on the BlueSnap. Setting the DTR line high will initiate the auto-connect process, and turning it off/low will cause a disconnect. 5-Auto-connect ANY Mode- This mode must be set by command. This mode operates like mode 4 DTR mode, except that each time the Switch/PIO is set, an inquiry is performed and the first device found is connected. The stored address is NOT used, and the found address is never stored. 3. ...

27 Cedar Park, TX, USA • (512) 994-3630 • [email protected] www.serialio.com line on the BlueSnap. Setting the DTR line high will initiate the auto-connect process, and turning it off/low will cause a disconnect. 5-Auto-connect ANY Mode- This mode must be set by command. This mode operates like mode 4 DTR mode, except that each time the Switch/PIO is set, an inquiry is performed and the first device found is connected. The stored address is NOT used, and the found address is never stored. 3. ...