Teradek Bolt Quick Start Manual

1. Support forum: http://support.teradek.com → Contains tips, information and all the latest firmware & software updates. 2. Training videos: http://www.teradek.com/training TERADEK SUPPORT STAFF: [email protected] or call 888−941−2111 ext2 (Mon−Fri 7am to 6pm PST) A: Battery Level B: USB Port C: Configuration Button D: Power Switch E: Charge LED F: 6-28VDC Input G: DC LED H: SD/HD/3G-SDI Output I: Video LED J: SD/HD/3G-SDI Input K: Video LED L: Link LED M: Ready LED A B C F H J I G E D Bolt Pro 3G-SDI Transmitter Bolt 3G-SDI Receiver H F L K M L K A: Power indicator B: USB Port C: Configuration Button D: Power Switch E: Charge LED F: 6-28VDC Input G: DC LED H: Video LED I: SD/HD/3G-SDI Input J: Video LED K: Link LED L: Ready LED M: SD/HD/3G-SDI Output A B C F H I G E D Bolt 3G-SDI Transmitter Bolt 3G-SDI Receiver M F K J L K J A: Battery Level B: USB Port C: Configuration Button D: Power Switch E: Charge LED F: 6-28V DC Input G: DC LED H: Video LED I: HDMI Input J: Video LED K: Link LED L: HDMI Output A B C F H I G E D Bolt HDMI Transmitter Bolt HDMI Receiver L F K J K J DEVICE OPERATION Keep the transmitter mounted vertically to ensure optimal signal transmission. Do not bundle Bolt receivers or transmitters together. For optimal performance, place multiple transmitters or receivers a few feet away from one another or other wireless devices. Notes: 1 2 Connect the Bolt Transmitter to your camera’s SDI or HDMI output. Connect the Bolt Receiver to your monitor’s SDI or HDMI input. Move the Bolt Transmitter power switch (D) to the ON position. Video appears within a few seconds. Connect power to your Bolt Transmitter using the P-Tap to 2-pin cable and Bolt Receiver using the included AC adapter. The transmitter contains an internal battery (in BOLT SDI Pro and HDMI versions) that lasts for up to 60 minutes. 1 3 2 AC adapter P-Tap to 2-pin cable SDI cable HDMI Cable

CUSTOM / 3RD PARTY CABLES OPERATION MOUNTING Bolt uses a 2−pin power connector. Pin Description 1* GND 2 +DC * Pin 1 is closest to the red dot on the power connector • Check the power cable for shorts / proper grounding. • DO NOT connect video when testing custom cables. Improper cable polarity and/or construction may cause damage to Bolt if video is connected. • For best results, allow 60 seconds after powering up the Transmitter and Receiver for them to select the best frequency. • For better signal quality over longer distances, maintain line−of−sight between the Transmitter and Receiver. • Mount the Bolt Transmitter vertically. • Mount the Bolt Receiver vertically with the face oriented towards the Transmitter. • Keep the antennas on the Bolt Transmitter and Receiver clear of obstructions. • Velcro is not recommended for mounting either Transmitter or Receiver. Bolt Transmitter mounted vertically on a camera Bolt Receiver mounted vertically on a monitor ALWAYS MOUNT BOLT TRANSMITTER VERTICALLY ALWAYS MOUNT BOLT TRANSMITTER VERTICALLY CAUTION: Damage to the product caused by custom cables is not covered under warranty.