RAB WPLED52 Installation Instructions

IMPORTANT READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED. WARNING: Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside. Thank you for buying RAB lighting fi xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments. Call the Marketing Department at 888-RAB-1000, or email: [email protected] Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation, operation or maintenance. MOUNTING TO A WALL 1. Orient box so that “TOP” is on top. 2. Secure Wall Mounting Box to a sturdy wall. Use appropriate mounting hardware such as lag bolts and anchors with washers suitable for the mounting surface. 3. Feed supply wires through Wall Mounting Box. Check that Gasket is fully sealed. 4. Bring fi xture up to the Wall Mounting Box and slide the stainless steel Tether from the fi xture into the Key Hole Slot for hands free wiring. 5. Wire the fi xture using suitable wire connectors. 6. Place wired fi xture over the Wall Mounting Box and tighten the Top Screws. Now tighten the Lower Screws. 7. Tighten Close Up Plugs and apply weatherproof sili- cone sealant to all unused conduit entry points. Also use sealant between the wall and Wall Mount Box. 4.57” 2.4” 1.09” .79” 3.0” Wall Feed Conduit Feed Hardware (not supplied) Wall Mount Box Top Screws Lower Screws WPLED52 Standard (15 Deg) WPLEDC52 Cutoff (7.5 Deg) WPLEDFC52 Full Cutoff (0 Deg) Close Up Plugs (4) Gasket Tether Key Hole Slot

TROUBLESHOOTING 1. Check that the line voltage at the fi xture is correct. Refer to wiring directions. 2. Is the fi xture is grounded properly? 3. Is the photocell, if used, functioning properly? WPLED52-IN-0711 WIRING Universal voltage driver permits operation at 120V to 277VAC, 50 or 60 Hz except fi xtures factory ordered with a 120V photocell (/PC) 1. Connect the BLACK fi xture lead to the (+) LINE supply lead. 2. Connect the WHITE fi xture lead to the (-) COMMON supply lead. 3. Connect the bare copper Ground wire from fi xture to supply ground. CLEANING & MAINTENANCE CAUTION: Be sure fi xture temperature is cool enough to touch. Do not clean or maintain while fi xture is energized. 1. Clean glass lens with non-abrasive glass cleaning solution. 2. Do not open the fi xture to clean the LED. Do not touch the LED. WPLED52 Cool WPLED52N Neutral