Nilfisk-Advance SC100 Operating Manuallines

Fax: +45 43 43 77 00 [email protected] www.nilfisk.com ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual. 2. Fill the solution tank with a clean water. The clean water temperature must not exceed 40 °C. 3. The tank cap can be used for dosing the detergent. One full cap is 30ml giving 1% detergent of the 3L tank capacity. (*) 4. Connect the power plug to the electrical socket. 1. Release the handle to remove the tank assembly. 19. Clean the squeegee bars and the cylindrical brush with water. 17. Remove the squeegee bars. 18. Unscrew by turning the knob clockwise to remove the cylindrical brush. 20. Clean the machine using a damp cloth and where needed use a neutral cleaning product. Then store the machine in a clean and dry place. 14. Disconnect the power plug from the electrical socket and rewind the cable from the machine and place it in the cable holder. 13. Park the machine in upright position. If needed turn off the machine by pressing the main button. Press the main switch to “0”. 9. Move the machine with the handle and start cleaning the floor. 11. The red LED blinks when the machine is getting low on solution and fixed light when empty. Empty the recovery and refill the solution tank to continue working. 12. To use the manual suction hose press the main button to start the machine in upright position. Turn the hose connec- tion to ON and use the suction tube. When done press the main button and turn hose connection to OFF. (**) 15. Empty the recovery and solution tank. Clean them with water. 16. Check and clean the solution and vacuum filter regularly. 10. For double scrubbing, use the pedal to lift/lower squeegees. 5. Turn on the machine with the main switch to “I”. 6. Use the orange pedal to put the machine in working position. 7. When machine is in working position press the main button and start cleaning. Machine will automatically stop when parked upright. 8. Press one of the solution buttons, according to the type of cleaning to be performed: 1 drop - normal cleaning 2 drop - heavy duty cleaning At the end of the work (*) ALWAYS FOLLOW THE DETERGENT DOSING RECOMMENDATION ON THE LABEL OF THE CHEMICAL PRODUCT USED. (**) THE MANUAL SUCTION HOSE IS INCLUDED ACCESSORY ONLY FOR THE FULL PACKAGE VERSION; FOR THE BASIC VERSION IS AN OPTION. Click OPERATING GUIDELINES SC100 ScrubVac 01309 676796 [email protected] www.scrubvac.co.uk

Fax: +45 43 43 77 00 [email protected] www.nilfisk.com The machine doesn’t work as it should? The suction doesn’t work as it should? The machine doesn’t clean as it should? The brush doesn’t work as it should? TROUBLESHOOTING SC100 1. Check if the power supply cable is damaged, faulty or disconnected from the electrical mains. 1. Check if the recovery tank is full. 1. Check if you have the right detergent solution settings or the solution tank is empty. 2. The main switch is broken. (*) 2. Check if the squeegee bars are dirty or the blades are worn or damaged. 2. Check if the solution filter is dirty. Clean it if needed. 1. Check if the cylindrical brush is correctly installed and not worn out. 3. The push button panel is broken. (*) (*) For these causes the maintenance procedure must be performed by an authorised Nilfisk Service Center. For further information refer to the Service Manual, available at any Nilfisk Service Center. 3. Check if the inspection compartment is dirty. 3. Check if the holes in solution dispensers are clogged. Remove them and clean if needed. 4. Check if the recovery vacuum hose is disconnected or dirty. ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual. ScrubVac 01309 676796 [email protected] www.scrubvac.co.uk