Erreka ULTRA Quick Installation And Programming Manual
Text of the manual
Quick installation and programming guide
English
WARNING
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and
other explanations which must be taken into account. The most recent version of this guide and the
installation manual are available at the "Downloads" section on Erreka's website:
http://
Choosing the spring and anchoring orifice
The balancing spring and its anchoring orifice depend
on the length (L) of the barrier arm:
ULS3EC Barriers:
•
Arm 2.0m < L < 3.0m:
spring D= 4.5mm, orifice 1
•
Arm 1.5m < L < 2.0m:
spring D= 4.5mm: orifice 2
ULS45EC Barriers:
•
Arm 2.5m < L < 4.0m:
spring D= 5.5mm, orifice 2
•
Arm 4.0m < L < 4.5m:
spring D
Balancing the barrier
Unlock
THE BARRIER MUST BE BALANCED FOR
PROPER OPERATION.
•
In order to complete the balancing, connect the
power supply and check operation: the barrier
should move smoothly, without jolts or jerks.
•
If it does not move smoothly, without any jolts or
jerks, reduce the tension of the spring using the
tensioning han
Opening photocells (SG.A): place DIP6 in
ON to enable testing.
Closing photocells (SG.C): place DIP9 in ON
to enable testing.
Photocell testing
Encoder
For the correct operation of the
encoder, ensure DIP7 is in ON.
(photocells without testing)
(photocells with testing)
230V, máx. 60W
F1 Motor fuse (5x20
SW2 functions during programming (DIP1 = ON)
DIP1=ON: programming enabled (DL3 lights up)
DIP1=ON and DIP2=ON: open/close programming
DIP1=ON and DIP4=ON: radio code programming
Radio code programming (only with RSD receiver)
1 Connect
the
electrical
power
supply and close the barrier by
keeping PUL1 pressed down.
2 Select the code in the transmit
