Laser DAB-DGHN Operation & User’s Manual

Radio. By following some simple precautions your device will give you years of trouble free service. Specifications: Radio Frequency: FM (87.5-108Mhz); DAB+ (5A-13f) Power -3 x AAA batteries (Alkaline recommended) Stereo Earphones (3.5mm) General warning: Do not place the unit near water, steam, sand or other environmental hazards. Avoid direct heat / sunlight sources such as outdoors, in vehicles or near heaters. The DAB-DGHN is designed for use in Australia and may not work in other countries For Service: Phone 1300 988 004 (9am – 5pm AEST) Email [email protected] Web www.laserco.net (or live support)

batteries for best performance. • Please note the orientation of the +/- battery polarity when inserting batteries. • If the DAB-DGHN is not going to be used for an extended period of time, it is recommended to remove the batteries. • When the battery power is low, the device will power off automatically. Please change the batteries

The first time the DAB-DGHN is switched on, the device will automatically scan for stations. The Earphones must be plugged in when station scanning occurs as the cord acts as the antenna. Please ensure that the side lock switch is in the “unlock position” Press the Power button Choose either DAB or FM mode Press the INFO button for 3 seconds Press the right arrow button then choose Auto Scan Press OK to confirm

To select stations, press the left or right arrow button, then press the OK button to confirm Press the VOL+ and VOL- button to adjust volume level Press the DAB/FM button to change between the FM radio frequency and DAB+ frequency The LOCK switch on the side prevents accidental button presses (eg; whilst in your pocket / bag) Automatic clock setting – the device will automatically update the time when tuned into a DAB+ station or an FM station with RDS. Setup Menu - Press the INFO button for 3 seconds Storing your favourite stations The DAB-DGHN can store up to 10 saved stations (presets) to allow for quick recall of saved stations.

1. Whilst listening to a station, press and hold the OK button for 3 seconds. 2. Press the right or left arrow button to select the preset number you want the station stored on. 3. Press and hold the OK button for approximately 3 seconds to store the preset (The station name will be recalled with the preset channel) NOTE: All Station names can be recalled when you press and hold the OK button. Recalling a stored station 1. Press the OK button for 3 seconds 2. Then use the right or left arrow button to choose the preset station 3. Press OK to confirm If a preset does not have a station saved, then "Preset XX" will be displayed.

Questions Answers Can I receive Digital Radio? Type your postcode into the search function at www.digitalradioplus.com.au or SMS your postcode to 0409 377 587 I can see station names on the display, but it says " N/A Signal" Possible reception issues: For DAB reception, signal strength can change in short distances. Move around to try different locations. Otherwise do the full scan again: Hold the INFO button for 3 seconds and choose Auto Scan The device turns off automatically after a few seconds Replace the batteries, preferably with new Alkaline batteries. In FM mode, what does " Force Mono" do? When in FM mode, the device will automatically switch between stereo and mono mode. In weak FM reception areas choose Force Mono. I have tried Auto Scanning but still cannot receive DAB+ stations. Reception may not be possible in remote areas or whilst obstructed (eg; tunnels or underground) The device seems to have lost reception where once it was ok. Hold the INFO button for 3 seconds; choose Set Up, then Factory Default to restore original settings. For more FAQ’s, please visit www.LaserCo.net