Hakko Electronics FX-889 Instruction Manual
Text of the manual
Thank you for purchasing the HAKKO FX-889 Soldering Station.
Please read this manual before operating the HAKKO FX-889.
Keep this manual readily accessible for reference.
Instruction Manual
1. PACKING LIST AND PART NAMES
Please check to make sure that all items listed
below are included in the package.
Color band
Instruction manual
1
1
1
1
2
1
HAKKO FX-889 S
3. WARNINGS, CAUTIONS AND NOTES
AC26V 65W
< 2 Ω
< 2 mV
Ceramic heater
1.2 m (3.9 ft.)
217 mm (8.5 in.) with B tip
46 g (0.10 lb.) with B tip
Power consumption 135W
* The temperature was measured using the FG-100 thermometer. * This product is protected against electrostatic discharge.
* Specifications and design are subject to change
4. INITIAL SETUP
A. Setup the iron holder
(1) Cleaning Sponge
1. Fit the small sponge pieces into the hollows of the
iron holder base.
2. Add an appropriate amount of water into the iron
holder base. The small sponge will absorb water
and help keep the large sponge damp at all times.
3. Dampen the large sponge and place it on the iron
holder base.
(2) Cleani
LED heater lamp
UP
ENTER
UP
ENTER
● Operation and indication
Switch and control button
UP
ENTER
The front panel of HAKKO FX-889 has two control buttons each for “A.IRON” and “B.IRON.”
– Use this button to select and change settings.
• In the temperature preset mode, pressing this button will change the selected preset tempe
1. Press and hold the button for at least
two seconds.
● is displayed. When you press the
button, the display will move to the adjust mode.
2. Changing from to .
● The procedure for changing the value in
adjustment mode is the same as setting the
temperature in normal mode.
Please refer to Section 5 - OPER
