CAME AX3024 Installation Manual

Dimensions (mm) Description of parts 1. Operator 2. Pilaster bracket 3. Gate bracket 4. M8x35 UNI5737 screw for securing pillar bracket 5. Bushing 6. M8 UNI5588 nut for securing pillar bracket 7. Sheath holder 8. Mechanical stop 9. M6X20 UNI5739 screws for mechanical stop 10. Endless screw pin 11. Ø8x24 UNI6593 washer 12. Gate bracket screw for securing to M8x10 UNI5739 pin 13. Secur ...

�� �� ���� p. 12 - Manual FA01165 -EN - 05/2018 - © CAME S.p.A. - Translated original instructions Fully close the gate-leaf, place the mechanical stop against it with the pin attachment and fi x it in place. Opening mechanical stop Attachment pin Fully open the gate-leaf, place the mechanical stop against it with the pin attachment and fi x it in place. Closing mechanical stop Attachment pin Connect the gearmotors to the panel as shown in the diagram. Power 230V a.c. 50/60 Hz Delayed closing action Delay ...

(non-issued) Supplementary bracket INWARD OPENING CONNECTIONS AND INSTALLING Fastening the braces Weld pillar bracket to the non-issued supplementary bracket, while gate is open, then secure the brackets to the pillar, making sure the “A” and “B” quotas shown in table 1 are met. Weld, or secure with proper screws, the gate bracket, making sure the “E” quota is met, as shown in table 1. Finally, secure the gearmotor to the brackets with the issued screws and washers. Opening A (mm) B ...

Extraordinary maintenance ⚠ The following table is for logging any extraordinary maintenance jobs, repairs and improvements performed by specialized contractors. � Any extraordinary maintenance jobs must be done only by specialized technicians. Extraordinary maintenance log Fitter's stamp Name of operator Job performed on (date) Technician's signature Requester's signature Job performed __________________________________________________________________________________________ __________________________ ...

Insert the bushing (lubricated) into the pillar bracket’s hole. The bracket has holes that allow the opening angle to be changed. Secure the tail joint to the bracket. Note: on non-metal gate leaves assemble and weld the two parts of the bracket and secure them with proper screws. Secure the tail joint to the bracket. Weld the gate bracket to the gate leaf making sure the quotas shown in the table are met. Note: for AX5024 gearmotors, require an additional 10 mm shim between the gat ...

Insert the bushing (lubricated) into the pillar bracket’s hole. The bracket has holes that allow the opening angle to be changed. Secure the tail joint to the bracket. Note: on non-metal gate leaves assemble and weld the two parts of the bracket and secure them with proper screws. Secure the tail joint to the bracket. Weld the gate bracket to the gate leaf making sure the quotas shown in the table are met. Note: for AX5024 gearmotors, require an additional 10 mm shim between the gat ...