Argos AVR 4 Seater Patio Set Assembly Instructions

Height - 70cm Issue 1 - 26/05/10 Please read these instructions fully before starting assembly If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400 800 Assembly Instructions - Please keep for future reference AVR 4 Seater Patio Set - Table 651/1555 Important –

manufactured from toughened safety glass. In the unlikely event that the glass fails it will break in to a large number of small fragments that may be spread over a wide area. This is a feature of toughened glass, designed to remove the risk of injure from glass breaking into large shards. If the glass is chipped or broken, stop using the product and consult the manufacture or supplier. Check you have all the components and tools listed on page 2. Remove all fittings from the plastic bags and separate them into their groups. Keep children and animals away from the work area, small parts could choke if swallowed. Make sure you have enough space to layout the parts before starting. Do not stand or put weight on the parts during assembly, this could cause damage. Assemble on a soft level surface to avoid damaging the unit or your floor. Dispose of all packing carefully and responsibly. Do not sit or stand upon horizontal glass surface. Do not place very hot or very cold items on the glass unless adequately thick tablemats are used to prevent such items from coming into contact with the glass. The unit weights approximately kgs. Warning: Please lift with care. Wash frame parts with mild soap and water, rinse thoroughly, and dry frame completely. Do not use bleach, acid, or other solvents on the frame parts. Wash glass with mild soap and water, rinse thoroughly, and dry glass completely. When moving the table, remove the umbrella. Do not drag. We recommend the use of furniture covers when not in use. Do not use the glass as chopping surface. Do not strike the glass with hard or pointed items. In order to prolong the life and beauty of your table, we recommend it be stored in a dry and protected area during off season periods. Do not use washing powders or any abrasive substances which may scratch the surface. 10

Please check you have all the parts listed below 2 Table leg x 4 Table top x 1 1 3 Center connector x 2 Note: The quantities below are the correct amount to complete the assembly. A Screw cap x 8 B Metal washer x 8 C D E Allenkey x 1 45mm Screw x 8 Please check you have all the fittings listed below Components - Fittings (Have already fixed on the leg tube) Plastic support x 4 2 Ruler - Use this ruler to help correctly identify the screws 0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170 105

tighten all screws until assembly is complete. C A 1 2 Place the table top 1 on a non-abrasive surface, such as carpet ,with the underside facing up. Insert the legs 2 into the plastic holders attached on the back of the table top rim 1 . Mount and align the center connector 3 to the middle of the legs 2 , then fasten them by using washers and screws . A C 3 E Important: Make sure the plastic support not detached from leg tube. E 2 2 3 2 1 Suggest to complete this product assembly by two person. 3 1

center connector 3 . Tighten all the screws and seal them with caps . A B If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400800 Argos Limited 489-499 Avebury Boulevard Saxon Gate West Central Milton Keynes Bucks,MK9 2NW Assembly is complete. cap Turn the table top 1 to its upright position and please remove the cap if you want to insert parasol. Warning: The parasol must be placed into the parasol's base if the table set need to match a parasol.