Logitech Y-X5A77 Installation Manual
Text of the manual
Ì«®² ÑÒ ½±³°«¬»®ò
Û²½·»²¼¿ »´ ±®¼»²¿¼±®ò
Ó»¬¬»¦ ´Ž±®¼·²¿¬»«®
-±«- ¬»²-·±²ò
Ô·¹«» ± ½±³°«¬¿¼±®ò
д«¹ ·² ËÍÞ ³·²·ó®»½»·ª»® ·²¬± ½±³°«¬»®Ž-
ËÍÞ °±®¬ò
ݱ²»½¬» »´ ³·²·®®»½»°¬±® ËÍÞ ¿´ °«»®¬±
ËÍÞ ¼»´ ±®¼»²¿¼±®ò
Þ®¿²½¸»¦ ´» ³·²·®7½»°¬»«® ËÍÞ
-«® ´» °±®¬ ËÍÞ ¼» ´Ž±®¼·²¿¬»«®ò
Ô·¹«» ± ³·²·ó®»½»°¬±® @ °±®¬¿ ËÍÞ
¼± ½±³°«¬¿¼±®ò
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful interference
in a
residential installation.
This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used
in
accordance with
the
instructions, may
cause
harmful interference
to
radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC
Caution:
Any
changes
or
modifications
not
expressly
approved
by
the
party
responsible for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept
any
interference
received,
including
interference
that
may
cause
undesired
operation.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. To maintain compliance with FCC RF exposure compliance requirements,
please avoid direct contact to the transmitting antenna during transmitting.