Roland S-4000S Installation Manual

This guide describes how to install S-BP (Blank Panel) in your S-4000S. Before you attempt installation, please read this document carefully. © 2006 Roland Corporation All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. When installing or detaching the S-BP, be sure to consult your RSS Authorized Service Center. After installing the S-BP, please be sure to return this document to the purchaser. • Always turn the unit off and unplug the AC plug before attempting installation of the S-BP. • Remove only the specified screws. • When the S-BP installation is complete, double-check your work. • Use a Philips screwdriver of the appropriate size to avoid damaging the screw heads (a number of 2 screwdriver). • Turn the screwdriver counter-clockwise to loosen the screws-turn it clockwise to tighten them. • Be careful not to let the screws drop inside the each unit. • Never leave a module uninstalled. Cover any unused slots with S-BP blank panels. • Be careful not to cut your hand on the edge of the circuit board or the opening edge wile removing the S-BP. For the Purchaser — Please Read For the Installer (Service Technician) — Please Read Cautions When Installing the S-BP tighten loosen

(SI-AD4 or SO-DA4) installed in the S-4000S. 2 Extract the module from the S-4000S. 3 Install an S-BP in the opening left by the removed module. 4 Secure the module in place using the two screws removed when detaching the module. Installing the S-BP to the S-4000S The module shown in the figure is the SO-DA4. The removal procedures for the SI-AD4 and SO-DA4 are the same. Extraction of the SI-AD4 or SO-DA4 may be accomplished more easily by inserting an XLR plug into a connector on the module, then pulling out the module while gripping the plug.