Forney Easy Weld Troubleshooting Manual

WELDING TIPS • Smooth bead • Minimal spatter • Good fusion • Stringy and lack of fusion • Lack of fusion • Excessive spatter GOOD WELD WELD SPEED TOO FAST CURRENT TOO LOW STICK OUT TOO LONG • Melt through or burn through • Too wide • Bead too flat • Visible melt through CURRENT/WFS TOO HIGH WELD SPEED TOO S ...

(Tool needed: screwdriver) Plug in welder. Turn it on, and squeeze trigger until wire comes out. Carefully tighten wire feed tension knob and despooler knob. Adjust wire feed speed and material thickness switch per setup chart. 1 Install wire spool per the diagram inside the cabinet. 2 3 4 5 6 7 Turn machine on, pull t ...