Duratrax ONYX 225 Quick Programming Manual

Quick Reference Guide to Programming NOTE: This guide does not replace the entire instruction manual as supplied with this charger. Read the provided manual in its entirety before use, paying particular attention to all safety warnings!! DTXP4225 QRG 1. START: Connect the charger to power. The CHARGE START screen will appear, with the active battery memory number shown in the top right corner (>0<). All settings for this memory will automatically scroll across the bottom of this screen or can be scrolled through using the ▼ and ▲ buttons. If these settings are acceptable for the battery to be charged, press and hold START and charge will begin. 2. SELECT A MEMORY: All ten memory profi les are pre-programmed with charge settings as shown in the chart. Press CHANGE then ▼ or ▲ to fi nd the correct profi le. Press CHANGE again to confi rm. Press and hold START and charging will begin. 3. MANUAL SETUP: Follow the steps below to fi nd the BATTERY SETUP screen to adjust the charger settings to match a specifi c battery. PRESS PRESS PRESS PRESS PRESS PRESS PRESS PRESS PRESS PRESS PRESS PRESS PRESS PRESS TO CHARGE START SCREEN BATTERY TYPE: Press CHANGE, then ▼ ▲ to find the proper battery type. Press CHANGE to confirm. CELL[02]: Press CHANGE, then ▼▲ to find the proper number of cells in the battery (confirmed by the voltage shown at the bottom of the screen). Press CHANGE to confirm. CAPACITY: Press CHANGE, then ▼▲ to find the rated capacity value of the battery. Press CHANGE to confirm. CURRENT: Press CHANGE, then ▼▲ to find the desired current. Press CHANGE to confirm. S_TIMER: Press CHANGE, then ▼▲ to find the desired backup safety timeout for charge. Press CHANGE to confirm. MELODY: Press CHANGE, then ▼▲ to change the melody type. Press CHANGE to confirm. BEEP OFF: Press CHANGE, then ▼▲ to turn ON or OFF. Press CHANGE to confirm. INPUT VOLTAGE: Shows the voltage at the charger’s input. OUTPUT VOLTAGE: Shows the voltage at the charger’s output. PEAK VOLTAGE: Shows the maximum voltage measured on the battery during charge. CHG CAPACITY: Shows how much energy was delivered to the battery during charge. CHG TIME: Shows how many minutes elapsed during the charge process. 5. START CHARGE: After all settings are made, press until the CHARGE START screen shows. Press and hold START for 2 seconds and fast charge will begin. MEMORY NO. Battery Type Cell Count Capacity (mAh) Current Safety Time (minutes) Delta Peak (mV/C) Trickle Current (mA) 0 LiPo 2 4000 4.0A 120 – – 1 LiPo 2 5000 5.0A 120 – – 2 LiPo 2 5700 5.7A 120 – – 3 LiPo 3 5000 5.0A 120 – – 4 LiPo 3 6400 6.4A 120 – – 5 NiCd 6 1800 1.8A 90 10 200 6 NiMH 6 3000 3.0A 90 8 250 7 NiMH 6 5000 5.0A 90 8 250 8 NiMH 7 3000 3.0A 90 8 250 9 NiMH 7 5000 5.0A 90 8 250 WARNING!! NEVER LEAVE A BATTERY UNATTENDED WHILE BEING CHARGED! REFER TO THE PROVIDED INSTRUCTION MANUAL FOR FULL DETAILS.