Rally 7424 Operation & User’s Manual

This listing is for reference purpose only. Some devices exceed the wattages listed. Before using device, refer to device owner’s manual for actual wattage required. Gamecube®with Intec Screen ......................................................................................................60 Watt Glue Gun .............................................................................................................................................20 Watt Cordless Drill Charger (7 Volt) ........................................................................................................15 Watt 13” LCD ................................................................................................................................................70 Watt DVD ......................................................................................................................................................45 Watt CD Changer .......................................................................................................................................65 Watt Cellular Phone Charger .................................................................................................................30 Watt Camcorder Charger (6 Volt) .........................................................................................................25 Watt Laptop .................................................................................................................................................80 Watt POWER SOURCE This Power Converter must be connected to a 12 Volt DC Negative Ground ignition system battery in good condition. Most vehicles are negative ground systems (see vehicle owner’s manual for ignition system identification). DETERMINE POWER REQUIREMENT To determine maximum power required, add up the wattage of all devices to be operated with this Power Converter simultaneously. If the wattage of devices is not available, but the current draw (amp) is given, simply convert to wattage using this formula: Volt (V) x Amp (A) = wAtt (w) Example: 110 Volt x 0.7 Amp = 77 watt CAUTIONS •� Do�not�place�this�Power�Converter�in�confined�spaces�or�inside�battery�compartment�of�vehicle�or�boat.�Use�only�in�properly�� � ventilated areas. •� Do�not�place�item(s)�over�the�Power�Converter.�Make�sure�that�air�is�allowed�to�circulate�freely�around�it. •� Do�not�place�the�Power�Converter�in�direct�sunlight�or�near�any�device�which�is�generating�heat�above�room�temperature. •� Do�not�operate�the�Power�Converter�in�ambient�air�temperature�below�-10°F�or�above�110°F.� •� Do�not�open�the�converter�housing�case. •� Secure�the�Power�Converter�and�device�being�operated�to�prevent�them�from�moving�while�the�vehicle�is�in�motion. •� Do�not�use�an�AC (110 Volt) extension cord longer than 25 feet. •� Do�not�use�a�12�Volt�DC extension cord of any type or length. •� Start�and�run�your�vehicle�hourly�to�prevent�battery�discharge.��IMPORTANT:�Disconnect�the�Power�Converter�and�turn�OFF�the� device being used before engine start up. •� Regularly�check�that�all�connections�are�secure�and�tight.��A�loose�connection�can�create�high�electrical�resistance�and�� � generate excessive heat which will damage the converter. •� Save�these�instructions�for�future�reference.