Kennedy Versa-Bench 4810 Assembly Instruction Manual

520 E. Sycamore Street • Van Wert, OH 45891 Phone 800-413-8665 • FAX 419/238-5644 www.kennedymfg. com Versa-Bench Model 4810 Assembly Instructions Style No. 4810 Part No. 527052, Rev. 7/05 BEFORE ASSEMBLY OF YOUR VERSA-BENCH® Check carefully to ensure that all parts listed on the reverse side are included. If any are missing, please call 800-413-8665 and ask for the Sales Dept. Do not discard packing material until assembly is complete. TOOLS REQUIRED Flat tip screw driver 7/16” Open end wrench or socket wrench 3/8” Open end or socket wrench

4 (B) 1/4” x 3/4” Hex Head Bolts 2 (C) 8” x 2” Swivel Casters 2 (D) 8” x 2” Rigid Casters 1 (E) Floor Lock 20 (F) 3/8” x 3/4” Hex Head Bolts 2 (G) “L” Shaped Aluminum Door Handle 4 (H) #8-18 x 3/8” Sheet Metal Hex Screws 1. Fasten chrome push handle (A) to end of bench as shown using (4) 1/4” x 3/4” hex head bolts (B). 2. Lift bench with a fork lift or lay on its back on shipping carton to install casters and floor lock. Remove bolts from wood shipping blocks from bottom of the Versa-Bench. 3. Fasten swivel casters (C), floor lock (E) and at opposite end attach rigid casters (D) with (4) each 3/8” x 3/4” hex bolts (F) to weld nuts in bottom. Carefully, set bench upright. Note: Swivel casters and floor lock should be located at same end of bench as chrome push handle. 4. Fasten door handles (G) to each door with (4) 3/8” sheet setal hex screws (H).