Suzuki UZ125 Owner's Manual

help you find the cause of some common complaints. FUEL SUPPLY CHECK 1. Make sure there is enough fuel in the fuel tank. 2. Make sure there is enough fuel reaching the carburetor. a.Loosen the drain screw located under the carburetor. Drain fuel from the car- buretor into a container. CAUTION Failure to troubleshoot a problem cor- rectly can damage your motorcycle. Improper repairs or adjustments may damage the motorcycle instead of fixing it. Such damage may not be covered under warranty. If you are not sure about the proper action ...

When the turn signals are being operated either to the right or to the left, the indicator will flash at the same time. NOTE: If a turn signal light is not operating properly due to bulb filament or circuit fail- ure, the indicator will flicker quickly to warn the rider of existence of a trouble. SPEEDOMETER 2 The speedometer indicates the road speed in kilometers per hour. HIGH BEAM INDICATOR LIGHT 3 The blue indicator light will be lit when the headlight high beam is turned on. ODOMETER 4 The odometer registers the total distance that the mo ...

Use this lock to set and lock the rear brake. To lock the rear brake lock, squeeze the rear brake lever and engage this lock. To release the rear brake lock, simply squeeze the lever until the lock lever releases. ...

cedure below: 1. Remove the mirrors. 2. Remove the screws. 3. Remove the front cover with the head lamp assembly 1. ...

IGNITION SYSTEM CHECK ....................7-4 INSPECTION BEFORE RIDING ..............4-4 INSTRUMENT PANEL .............................2-7 K KEY ..........................................................2-5 KICK STARTER LEVER.........................2-15 L LEFT HANDLEBAR..................................2-8 LIGHT BULB REPLACEMENT...............6-41 LOCATION OF PARTS ............................2-2 LUBRICATION POINTS...........................6-8 M MAINTENANCE SCHEDULE.................. 6-2 MAXIMUM THROTTLE OPENING RECOMMENDATION.......... ...

buretion. Do not attempt to alter its setting. There are two items of adjustment, however, under your care: idle speed and throttle cable play. Adjust the carburetor idle speed and throttle cable play periodically. IDLE SPEED ADJUSTMENT 1. Start up the engine and let the engine run until it warms up fully. 2. After engine warms up, turn the throttle stop screw 1 located on the carburetor in or out so that engine may run at 1400 – 1600 r/min. Use a commercially avail- able screwdriver to turn the throttle stop screw. THROTTLE CABL ...