Summit SCR314L Operation & User’s Manual

This beverage cooler includes a stainless steel handle that is not required to operate the unit. To install the handle, follow the instructions below: 1. Remove the door gasket on the side you wish to install the handle - you can see two designated holes for handle installation. The gasket is easily displaced by hand, no tools are necessary. 2. Install the handle tightly as shown with two screws and flat washers provided. (DO NOT over tighten as this will cause damage to the handle and stainless steel door frame). 3. Replace the door gasket to its original positi ...

Appliance Safety 2 Important Safeguards 2 - 4 Location of Parts 5 Installation Instructions 5 - 7 Before Using Your Appliance 5 Installation of Your Appliance 5 Electrical Connection 6 Extension Cord 6 Installing the Door Handle and Reversing the Door Swing 7 Operating Your Appliance 8 Control Panel Door Lock Defrosting Shelves Care and Maintenance 9 Cleaning Your Appliance Power Failure Vacations Moving Your Appliance Energy-Saving Tips Troubleshooting 10 Limited Warranty 11 ...

damaged, have it replaced by a qualified electrician or an authorized service center. This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of electrical shock. Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For personal safety, this appliance must be properly ...

It is recommended you install the appliance in a place where the ambient temperature is between 72º and 78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the performance of the unit may be affected. For example, placing your unit in extremely cold or hot conditions may cause interior temperatures to fluctuate. The range of 34-46ºF (1-8ºC) may not be reached. CONTROL PANEL Mechanical Control 1. There is TEMP-ADJ knob inside of beverage cooler. The temperature is adjusted in the range 34-46°F (1-8°C) in the cabinet. 2. ...

Appliance Safety 2 Important Safeguards 2 - 4 Location of Parts 5 Installation Instructions 5 - 7 Before Using Your Appliance 5 Installation of Your Appliance 5 Electrical Connection 6 Extension Cord 6 Installing the Door Handle and Reversing the Door Swing 7 Operating Your Appliance 8 Control Panel Door Lock Defrosting Shelves Care and Maintenance 9 Cleaning Your Appliance Power Failure Vacations Moving Your Appliance Energy-Saving Tips Troubleshooting 10 Limited Warranty 11 ...

CLEANING YOUR APPLIANCE Turn off the power, unplug the appliance, and remove all items, including shelves. Wash the inside surfaces with a solution of warm water and baking soda (about 2 tablespoons of baking soda to a quart of water). Wash the shelves with a mild detergent solution. Wring excess water out of the sponge or cloth when cleaning the area where the controls are located, or any electrical parts. Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth. Do not use steel wool or a steel brush on the sta ...

suggestions below to see if you can solve the problem before calling the service technician. Troubleshooting Solutions Check the voltage of the installation. LED lights are broken ...