Pneumercator TMS 3000 Quick Reference Manual

Page 1 of 2 July 1, 2009 TMS Quick Reference Guide Alarm LEDs* Display Mode LEDs LEAK – In-Tank / Sensor GAL – Gross Volume (Gallons) Net Volume (with ºF LED on) SP1 – Above 95% (High High) %GAL – Percent of Capacity SP2 – Above 90% (High) ULL – Ullage Vol (Gallons, Default 90%) SP3 – Below 20% (Low) IN – Product Level (Inches) Water Level (with “u” symbol, inches) WATER – Above 2” ºF – Product Temperature (ºF) Front Panel Buttons PAPER FEED PRINT MODE TANK SELECT TEST Press to advance Press for Current Press to display tank name. Press to select tank Press to test paper Inventory / Sensor Press and hold until beep Press and hold until display and Status report to select display mode beep for autoscan horn STEP GROUP SELECT EDIT Current Inventory / Sensor Status Report: Press PRINT button. * If an alarm LED is blinking, an active tank alarm is present on a tank(s) not currently being displayed. When an alarm LED is on continuously, it applies to the currently displayed tank. Note that this alarm may apply to more than one tank, which can be determined by viewing each tank with the TANK SELECT button. Site Name Tech Support Phone Site Location Emergency Phone Audible Alarm Acknowledgment To silence an alarm, press any of the right three buttons. The visual indicator will remain active as long as the alarm condition persists. A theft alarm can only be silenced by pressing the ACKNOWLEDGE pushbutton located on the inside of the front door. Visual Alarm Acknowledgment The only visual alarms that can be cancelled are failed in-tank leak test and no monthly in- tank leak test. These visual alarms are deactivated by pressing the ACKNOWLEDGE pushbutton located on the inside of the front door. All other visual alarms are persistent until remedied.

Page 2 of 2 July 1, 2009 Print Log Procedure Print Log(s) selected log Return Return Return Return selected log Log Log Log Log Return Return Return Return Log Log Log Log Return Return Return Return normal mode Return to Normal Display Mode* Inventory Inventory Inventory Inventory L E G E N D Log Log Log Log Enter Access Mode Press and release. Press and hold until second beep. Flashing Display While holdin Note: the list of logs may vary with the version of firmware in the TMS. g the TEST button, hold the MODE button until is displayed, then release buttons. , EDIT EDIT , , , or , , STEP EDIT EDIT , , or EDIT , Inventory Inventory Inventory Inventory Log Log Log Log Inventory Inventory Inventory Inventory xxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxx selected log *Return to normal tank gauging display mode may also be achieved by allowing console to timeout for four minutes with no pushbutton activity. 1. 2. 3. PRINT rEturn Events ALarms tank Leak LIne Leak Water Orders tHefts saLes deLivery Inventory Leak Hist