PolyVision CopyCam Installation Manual

To configure CopyCam: 1 On a computer connected to the same LAN and subnet as the CopyCam installation, insert the CopyCam installation CD-ROM. 2 Double-click the “setup.html” file. 3 Click “Start” to locate all CopyCams on your LAN and display their IP addresses. NOTE: NOTE: If no CopyCams appear, close the window and once again double- click the “setup.html” file. (CopyCam performs IP address squatting only after the first time you click “Start.”) 4 Click the IP address link to the CopyCam web site. The CopyCam web page appears, as shown. 5 If ...

free from defects in material and workmanship for a period of one year from the date of purchase. During the warranty period, and upon proof of purchase, the product will be repaired or replaced (with the same or similar model) at our option, without charge for either parts or labor. Shipping costs will apply. Please keep your original sales receipt or delivery invoice for proof of purchase. Without proof of the purchase date, your warranty will be defined as beginning on the date of ma ...

7 MOUNTING THE CONTROL PAD AND CAMERA ARM Expect to spend about two hours on this installation. PLANNING FOR WIRING CopyCam has three cable connections that converge in the camera arm, as shown below. CopyCam wiring can be either: • against a wall, the typical approach for adapting an existing facility, or • within a wall, a potential for new construction or renovation NOTE: NOTE: Use the positioning templates provided to assure proper location of the control pad and camera arm. Failure to do so may result in inhibited access to the floppy disk drive ...

PREPARING TO INSTALL THE CAMERA ARM WARNING You must fasten the brackets to the wall so they are secure. CopyCam mounts to any kind of wall construction. Instructions and wall fasteners are provided to help you install CopyCam when walls have metal or wood studs. Be sure to locate studs and use them to drive mounting screws if possible. Locate and have ready to use: • camera arm positioning template • camera arm • camera arm mounting plate • 2 8-32 mounting screws (provided) • 2 #8 x 1.5 inch drywall screws (provided) • 3 toggle bolt screw ...

7 MOUNTING THE CONTROL PAD AND CAMERA ARM Expect to spend about two hours on this installation. PLANNING FOR WIRING CopyCam has three cable connections that converge in the camera arm, as shown below. CopyCam wiring can be either: • against a wall, the typical approach for adapting an existing facility, or • within a wall, a potential for new construction or renovation NOTE: NOTE: Use the positioning templates provided to assure proper location of the control pad and camera arm. Failure to do so may result in inhibited access to the floppy disk drive ...

as shown below. If your board is 4' x 8' or less, put the four matching calibrations sheets in the corners. NOTE: NOTE: To attach the sheets to the board, use low gloss tape or put tape on the BACK of each sheet. Be sure that all four corners are taped securely. 3 Choose one of the two larger calibration sheets based on the type of board: whiteboard or blackboard (or any other dark- colored board). The calibration sheets are clearly labeled. Position this fifth calibration sheet at the top center of t ...