Planet VDR-301n Quick Installation Manual

Note – 1 – – 2 – – 3 – – 4 – Front Panel of VDR-301N Interfaces and Ports of VDR-301N VDR-301N Quick Guide RJ11 Cable VDSL Splitter Thank you for choosing PLANET VDR-301N. Before installing the AP, please verify the contents inside the package box. If there is any item missing or damaged, please contact the seller immediately. Step 1: Connect the Power Adapter to VDR-301N. Check whether the PWR LED and LAN LED on the front panel are on accordingly. Step 2: Follow the figure below to connect the network devices. VDR-301N Quick Installation Guide 802.11n Wireless VDSL2 Bridge Router Power Adapter RJ45 Cable 2. Physical Introduction 3. Hardware Installation Power Adapter Power LINE PHONE MODEM Power Adapter Power RJ11 RJ45 PC/Laptop Splitter Phone Jack Telephone PHONE MODEM DSL WAN WLAN Power 12V DC WPS Reset LAN1~4 Power DSL WPS WLAN Internet LAN1~4

– 8 – – 5 – – 6 – The above steps introduce the simple installation and configura- tions of the VDR-301N. For further configurations of different operation modes, please refer to the user manual, which can be downloaded from the website. http://www.planet.com.tw/en/support/download.php?type1=32 0&model=48957&type=3 If you have further questions, please contact the local dealer or distributor where you purchased this product. Steps: Set your computer to get an IP address from the Wireless Router: 1. Click the “Start” button located at lower-left corner of the screen. 2. Click “Control Panel”. 3. Double-click “Network and Sharing Center” icon. 4. Click “Change Adapter Settings”. 5. Double-click the “Local Area Connection” icon. 6. Select “Internet Protocol Version 4 (TCP/IPv4)” and click the “Properties” button. 7. Select “Obtain an IP address automatically” and “Obtain DNS server address automatically”, and then click the “OK” button twice to save the configuration. VDSL2 Router with PPPoE: Follow the steps below to set up connection to PPPoE mode. 1. Log in the VDR-301N’s web-based configuration utility. 2. Click “Setup”. 3. Select “DSL WAN”. 4. Choose PTM, and then select the Channel Mode to “PPPoE”. 5. Select the IP Protocol to “IPv4”. 6. Fill in User Name and Password which are provided by ISP. 7. After setting it up, press “Add”. If you need more information about WAN service, please refer to the User’s Manual. VDSL2 Router with Bridge: Follow the steps below to set up connection to Bridge mode. 1. Log in the VDR-301N’s web-based configuration utility. 2. Click “Setup”. 3. Click “DSL WAN”. 4. Choose PTM, and then select the Channel Mode to “Bridge”. 5. Select the IP Protocol to “IPv4”. 6. Press “Add”. If you need more information about WAN service, please refer to the User’s Manual. Default IP Address: 192.168.1.1 Default User Name: admin Default Password: admin Default SSID: PLANET_XXXX (“X” means the last 4 digits of the MAC address.) Now, you can see the Web management UI of the VDR-301N. 4. Web Login 5. Broadband Connection for VDSL Further Information PLANET Technology Corp. 11F., No. 96, Minquan Rd., Xindian Dist., New Taipei City 231, Taiwan 2011-AC0390-000