SimpliSafe U9K-BS2000 Setup Manual

A Follow this guide or download the SimpliSafe app for easy installation. S E T U P G U I D E ...

Welcome to SimpliSafe Personalize Settings Step 2: Test Your System Step 3: For FAQs and troubleshooting see pages 18 - 21 Install your System 1–13 Step 1: 14–15 16 For details on your 3-Year Warranty see page 22 For tips on using your system see page 17 B ...

1 Plan Your Installation Base Station Central location Glassbreak Sensor Near window 105 Decibel Siren Central location Freeze Sensor Near thermostat Entry Sensor On doors and windows Water Sensor Near water heater Motion Sensor On a shelf or adhere 4–5 ft high in a corne ...

2 Step 1. Install your Base Station • Set up your Base Station in a central location in your house. Don’t install it on the floor. • Plug the Base Station into a power outlet using the included power cord. Make sure the power outlet is not controlled by a light switc ...

3 Install your Keypads • Remove the battery activation strip. • Adhesive tape has already been installed on the back of the Keypad – just peel and stick. If you make a mistake, see “How do I move a sensor?” on page 18. • Adhere the Keypad to the wall by your mai ...

4 Install your Motion Sensors • Remove the battery activation strip. • Place the Motion Sensor on a shelf or adhere it to a wall, approximately 4 to 5 ft off the ground. Helpful Information about your Motion Sensor If you have large pets weighing more than 30 lbs, you c ...

5 Install your Glassbreak Sensors • Remove the battery activation strip. • Adhere the Glassbreak Sensor close to a bank of windows or on a wall facing your windows. • You can install it up to 20 ft away from the windows you’d like to protect. Helpful Information abo ...

6 Install your Entry Sensors • Remove the battery activation strip. • Align the magnet with the sensor so the two pieces are less than 2 inches apart when the door or window is closed. When the door or window is closed, the magnet should be within 2 inches of the sensor ...

7 Install your Panic Buttons • Remove the battery activation strip. • Adhere the Panic Button to a wall. • Most people install one in their master bedroom. Helpful Information about your Panic Button To trigger a panic alarm, firmly press your Panic Button for 2 full ...

8 Install your 105 Decibel Sirens • Remove the battery activation strip. • Indoor Installation: Adhere the Siren in a central location within 100 ft of the Base Station. • Outdoor Installation: Install within 100 ft of your Base Station. Slip the backing bracket off ...