Friedrich S S 08 Installation And Operation Manual

NOTE: SCREW AND NUT ORIENTATION NOW REVERSED. NOTE: HOLES IN SILL PLATE MOVED TO BACK SIDE TURN SILL PLATE END TO END SILL PLATE CABINET CABINET DETAIL A R E T F A E R O F E B DETAIL B DETAIL C FRR027 MODEL A SMALL CHASSIS 7-3/8” MEDIUM CHASSIS 7-3/8” LARGE CHASSIS 15-1/8” 2" MINIMUM BOTH SIDES CONDENSER AIR INTAKE LOUVERS A CONDITIONED ROOM SIDE AIR TOP VIEW CONDENSER AIR INTAKE LOUVERS MAXIMUM WALL THICKNESS TOP VIEW SHOWING BEVELED SIDES FOR AIR INTAKE. WALL BELOW UNIT MUST BE BEVELED ALSO ...

modes of operation: AUTO HEAT Not available on some models FAN ONLY COOL MODE SET POINT F AUTO FAN FRR103 FRR105 SET POINT F AUTO FAN FRR104 - AUTO-, COOL or HEAT or FAN ONLY mode, you can also select FAN MODE, FAN SPEED, TIMER SCHEDULE, . The SYSTEM MODE does not change. HEAT MODE FAN ONLY MODE AUTO FAN (No Cooling Demand) When in the AUTO FAN mode, the fan only operates when the system has a demand to cool or heat the room. Note: the fan is off (no fan speed icon), indicating no command for cooling or he ...

NOTE: Hardware and accessories used during installation are shown on page 23. Each part will be referred as Item No. STEP 1. Remove the chassis Entrygard retainer by removing the far right screw (See Figure 15), save this screw to reattach the chassis retainer after installation (Step 12). Also, remove and discard the two retainer screws and washers located at the rear of the unit (See Figure 15). CAUTION Handle Use Use handle on both sides to pull unit from sleeve. Do not push, pull or lift from center of support. FRR011 RETAINER SCREWS AND WASHERS FAR RIGHT ...

Heat pumps operate differently If your unit is a "Y", or heat pump model, there are some things that you will want to be aware of. Some functions of a heat pump differ from your unit when it is used for heating: 1. ice to form on the outdoor coil of the heat pump. Moisture in the outside air, passing over the coil when very cold, will form ice. 2. If the outdoor temperature drops below 37° F (3° C), your heat pump will automatically turn on the electric resistance heat. When the temperature rises to 40° F (4° C), the compressor will resume the hea ...

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is a safety Alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol with the word “WARNING” or “CAUTION”. These words mean: Indicates a hazard which, if not avoided, can result in severe personal injury or death and damage to product or other property. Indicates ...

FRR059 ELECTRICAL CONTROL PANEL Figure 36 STEP 20. Reinstall the 3 screws removed earlier to secure electrical control panel. FRR060 ELECTRICAL CONTROL PANEL SCREWS (3) (RETAINED FROM STEP 1) STEP 21. If running power cord to the right of the unit install the cord into the cord retainer clips along the bottom front of the unit. FRR061 CORD RETAINER CLIPS FRONT GRILLE POWER CORD Figure 37 Figure 38 ...

The $MART icon illuminates to indicate that the system is being controlled remotely. SET POINT F AUTO FAN 79 FRR125 $MART The icon illuminates to indicate that the system is receiving a Wi-Fi connection. SET POINT F AUTO FAN 79 FRR126
    
    1. Timer (factory default)          the start, stop and day window can be found latter in this manual. 2. Residential Schedule - When selected the unit follows a pre- programmed set of op ...