DSC PC5020 Power864 Installation Manual

17 [*] [0] Quick Arm If the Quick Arm Enable option is enabled the panel can be armed by entering [*][0]. This is a useful method of arming a partition when someone without an access code will be required to arm a partition. [*] [0] Quick Exit Quick Exit will allow someone to leave an armed premise through a Delay type zone without having to disarm and rearm the system. When [*][0] is entered, if the Quick Exit Enabled option is enabled, the panel will provide a 2-minute window to exit. During this time the panel will ignore the f ...

25 Option Definition On/Off Description 2 Bell During Auto- arm ON Bell Squawk During Auto-arm Enabled. The bell output will sound a single squawk every 10 sec- onds during the Auto-arm Pre-alert time. This will inform anyone on the premises that the system is being armed. OFF Bell Squawk During Auto-arm Disabled. The bell output will not be activated during the Auto- arm warning time 3 Bell Squawk On Exit ON Bell Squawk On Exit Delay. The bell output will squawk once per second during the Exit ...

• 1 system account number, plus 8 partition account numbers • Supports LINKS1000, GSM1000 cellular communica- tion, Links 2X50 long range alarm transmitter and Sky- route™ Cellemetry communication transceiver • DTMF and pulse dialing • DPDT line seizure • Anti-jam detection • Event-initiated personal paging • T-Link communications via PC-Link (see T-Link Instal- lation Manual part no. 29001007) System Supervision Features The PC5020 continuously monitors a number of possible Trouble conditions including: • AC power failure • Trouble by ...

The structure of this section corresponds with the structure of the Programming Worksheets (PWS) and is intended to be used with them. Paragraph 5.1 corresponds with Section 1 etc. Table 5-1 references the paragraphs in this section with the corre- sponding location in the programming worksheets. Table 5-1 - SECTION 5 CONTENTS Sect Item Sect Item Para 5.1 For the Record 378 Test Transmission Time of Day Para 5.2 Keypad Programming 380 First Communicator Option Code Para 5.3 Basic Programming 381 Second Communicator Option Code 001-004 Zone Definitions 382 Thi ...