Campomatic D807e Instruction Manual

Electric diagram ENG English .................................................................................................................... 2 French ..................................................................................................................... 22 2

sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. D807e / D807es ENG 4

which it was designed. Only wash fabrics which are designed to be machine dried.Follow the instructions on each garment label Any electrical work required to install this appliance should be carried out bya qualified electrician or competent person. If the machine is situated on a carpeted floor,please adjust the feet in order to allow air to circulate freely under the appliance. Do not climb onto the dryer or rest heavy objects/heating devices or items with water or liquid leakage on the dryer,lest deformation of the face panel and the plastic component occur. Any objects such as coins,safety pins,nails,screws,stones or any other hard,sharp material can cause extensive damage and must not be placed into the machine. After having installed the appliance,check that it is not pressing or standing on its electrical supply cable,or vent hose. Items such as foam rubber(latex foam),shower caps,waterproof textiles,rubber backed articles and clothes or pillows fitted with foam rubber pads should not be dried in the tumble dryer. Always unplug the appliance after use,clean and maintenance. Do not overload the appliance.See the relevant section in the user manual. Clothes which are dripping wet should not be placed in the dryer. Garments which have been in contact with volatile petroleum products should not be machine dried.If volatile cleaning fluids are used,care should be taken to ensure that the fluid is removed from the garment before placing in the machine. Never use the tumble dryer if the power supply cable,the control panel,the working surface or the base are damaged so that the inside of the tumble dryer is accessible. The tumble dryer is not to be used if industrial chemicals have been used for cleaning. The lint must not to be allowed to accumulate around the tumble dryer. Do not dry unwashed items in the tumble dryer. Fabric softeners or similar products should be used as specified by the fabric softener instructions. The final part of a tumble dryer cycle occurs without heat (cool down cycle) to ensure that the items are left at a temperature that ensures that the items will not be damaged. That exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels. That the appliance must not be installed behind a lockable door,a sliding door or a door with a hinge on the opposite side to hat of the tumble dryer,in such a way that a full opening of the tumble dryer door is restricted. That adequate ventilation has to be provided to advoid the back flow of gases into the room from appliances burning other fuels,including open fires. The exhaust air must not be discharged into a fule which is used for exhausting fumes from appliances burning gas or other fuels. D807e / D807es ENG 5

2.Sequence lindicator Lights 4.Delay Button and Lights Drying 5.Delicate Cooling 6.Quick End Filter D807e / D807es ENG 7

standby mode if you have not pressed the Start/Pause button for 10 minutes.The filter indication light will still keep on until power off. D807e / D807es ENG 8

The countdown begins af . If you have selected a delay time by means of the relevant button, the light shows it.The D807e / D807es ENG 9

button. The appliance will start the delayed process. If you (a)press one more "start/pause", the unit will not pause and still countdown. (b)turn the rotation knob be "off", the program will be cancelled. (c)want to change the program, then you have to turn the rotation knob be "off" and make the program selection again. and program "30min","60min" and "90min". D807e / D807es ENG 10

kerosene, spot removers, turpentine, waxes and wax removers should be washed in hot water with an extra amount of detergent before being dried in the tumble dryer. Remove all objects from pockets such as lighters and matches. D807e / D807es ENG 13

e.g.terry towelling items.For drying individual items of laundry or for small volumes. Normal Humid Iron Heavy Normal Iron 30’,60’,90’ Anti-Bacterial Silk Fresh Dry Air Dry 8kg 8kg 8kg 8kg 8kg 3kg 3kg 3kg 8kg 3kg 1.5kg 3kg 2kg D807e / D807es ENG 14

Adjust the adjustable feet to lower the dryer by turning right and to ascend it by turning left. Tighten the locknut after insuring the dryer is level. D807e / D807es ENG 18

outlet at the back, aligning arrows of hose and ring nut,fastening by screwing hose to the direction of arrow and pushing it firmly back into place. Advice: If the hose is long and the room temperature low, the moisture might condense inside the hose. This is an unavoidable natural phenomenon. To prevent this water from Iying in the hose or flowing back into the tumble dryer, it is advisable to drill a small hole (dia. 3 mm) in the lowest point of the hose and to place a small container below it.(See picture, point B). A Once connected to the dryer, run the vent hose to the desired outlet point, it contains no more than two bends. As to the outlet itself, if you have decided on a fixed wall/window grille, a good local builder's merchant should be able to supply you with the necessary fittings and installation advice. B A D807e / D807es ENG 19

carried out by qualified personnel .Please contact the nearest our Service Centre. This will be a chargeable option. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Electrical connection THIS APPLIANCE MUST BE EARTHED. Warning Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance's rating plate. Should the plug need to be replaced for any reason, proceed as described below. The wires in the mains lead are coloured in accordance with the following code: Green and Yellow-Earth Blue-Neutral Brown-Live The wire coloured green and yellow must be connected to the terminal marked with the letter or by the earth symbol or coloured green and yellow. The manufacturer declines any liability should this safety measure not be observed. That adequate ventilation has to be provided to avoid the back flow of gases into the room from appliances burning other fuels, including open fires. For appliances with ventilation openings in the base, that a carpet must not obstruct the openings. It is important not to connect the vent hose to, for example, a cooker hood, or a chimney or flue pipe designed to carry the exhaust from a fuel burning appliance. Note that to avoid condensation problems, it is essential that the dryer be fitted with the flexi- ble hose to carry its auste outside the kitchen. In order to prevent the appliance from overheating, it is important that the steam exhaust is unobstructed. If the dryer is fitted next to kitchen units, make sure that the vent hose is not squashed. If the hose is partially squashed, drying efficiency will be reduced, resulting in longer drying times and higher energy consumption. If the hose is completely squashed, the safety cut-outs with which the machine is fitted may operate. When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. D807e / D807es ENG 20

ENG 21