DCS RF151 Service Manual

ice. 10. Room and/or water temperature is too warm. Move the unit to an area where ambient temperature is below 90 degrees F. The unit should not be placed next to a heat source such as an oven. Check for cold water connection. 11. Leaking drain valve. See “Cleaning Your Ice Maker” section for cleaning the unit. This will also dissolve and flush out foreign material in the drain valve causing it to leak. If this does not stop the drain valve from leaking, the drain valve will need to be replaced. 12. Evaporator ...

8. Correcting damage caused by pests e.g. rats, cockroaches etc. 9. Used in commercial applications. B. Defects caused by factors other than: 1. Normal domestic use or 2. Use in accordance with the Product’s Use and Care Guide. C. Defects to the Product caused by accident, neglect, misuses, fire, flood or Act of God. D. The cost of repairs carried out by non-authorized repairers or the cost of correcting such unauthorized repairs. E. Travel Fees and associated c ...

cally. 2. Discharge line is restricted or kinked. Check the discharge line and connection to the desired drain for any restrictions or kinks and repair as necessary. 3. The drain pump is not level. THE DRAIN PUMP MUST BE LEVEL. Check for level on the top of the drain pump case and adjust the tubing or use shims to level. Troubleshooting Guide ...

Bend hot gas valve tubing similar to the one being replaced. DO NOT KINK TUBING OR OVERSTRESS TUBING AT VALVE JOINTS. 1. Braze in the new drier assembly and then the capillary tube. 2. APPLY A HEAT SINK OR A DAMP CLOTH ON THE VALVE BODY TO KEEP HEAT AWAY. Be sure to keep heat sink or water from 3. entering the tubing. Failure to keep the valve body cool will result in a leaky valve. Braze the hot gas valve tube (from the side of the valve) into the tee on the drier assembly. 4. Braze the hot gas valve tube (from the bottom of the valve) into the evaporator b ...

2. The grid-cutter is not plugged into the receptacle. Remove the escutcheon panel and plug cutter-grid into the receptacle on the side of the line. 3. Time to cut through the slab. It can take up to 35 minutes to cut through a harvested ice slab. This is normal operation. Ice cubes are sticking together. 1. Ice consumption is low. Use the ice in the bin frequently. Ice will stick together if left in an insulated bin over long periods of time. 2. Room temperature is too warm. Move the unit to an area where tempera- ...