Contacta HLD3 Installation Manual
Text of the manual
Components .......................................................................................................................................................... 1
Loop Installation Options ..................................................................................................................................... 2
Loo
Loop Installation Options
The loop pad can be used if the loop is going to be used by one person, and that person generally sits
in the same sear. If two people will be using the loop, two loop pads can be used with the proper
adapter cable. The loop pad is effective only when the hearing aid wearer is sitting directly above it.
Loop wire
Loop Pad Installation
Place the loop pad underneath the seat that the hearing aid wearer will be sitting in. It can be placed
underneath a cushion, on the floor beneath the seat, or attached underneath with velcro. The wire
coming out of the loop pad can run around the edge of the room to the HLD3. It is ok for the wire to go
around a door
Loop Wire Installation
The loop wire can be placed in a section of the room or around the whole room. Start from where the
HLD3 will be placed loop the wire around the room and back to where the HLD3 driver will be.
Trim the wire down if there is any excess.
Connect both ends of the loop to the terminal on the HLD3. The wires can be connect
HLD3 Driver Connection
Overview
A. Power
B. Loop Pad / Loop Wire
C. Optical / Digital In
D. High Frequency Compensation
E. Line Out
F. Line In
G. Microphone
Optical
If your TV has an optical output, remove the plug from the rear of the HLD3 (C) and connect the
optical cable, then connect to the TV.
Plug in the power supply to the HLD3 (A) a
