Contest Ninja 7x15QC Operation & User’s Manual

Page 6 English 6 - Cabling, addressing and daisy chaining Connecting the DMX remote control : Connect the female plug of your XLR cable to your DMX remote control XLR output, then connect your cable male output to the moving head. Daisy chain your moving heads with XLR cables. 1 2 R 3 120 Ω 1/4W Using a DMX line termination : When long runs of cable are used (more than 100m), you may need to use a terminator on the last unit to avoid erratic behavior. A terminator is a 110-120 ohm 1/4 watt resistor which is connected between pins 2 and ...

Page 18 English Once switched on the unit will launch an initialisation. The display will indicate "Error channel is XX" if a problem occurs with one or several channels. The XX variable may correspond to 1,2,3,4,5, or 6 since these are movement-dedicated channels. Errors may have various origins. Sensors are used to set the motors in their default position. Either the magnetic sensors are defective, or the magnets have been displaced. Problems might also come from a defective motor or the motor electronic management. In any case, please ...

Page 4 English 8 - DMX output via 3-pin XLR 9 - DMX input via 3-pin XLR 10 - Power switch 11 - Fuse Fuse : T3.15A - 250V ; 5 x 20 mm 12 - Power input socket Powercon© Neutrik© 13 - Power output socket Powercon© Neutrik© 4 - Description 1 - Lens 2 - DC switch button Switches the menu on when the moving head is not plugged. 3 - MIC Used for music-sensitive modes. 4 - Display Allows you to visualise menus. 5 - MODE/ESC button Enters/leaves menus. Allows you to browse through menus and change values. 6 - ENTER button Selects functions an ...

Page 13 English The Ninja-7x15QC moving head includes 3 preset DMX modes : The Basic mode features 15 channels, the Standard mode features 17 channels and the Expert mode features 21 channels. The following chart indicates DMX values of each channels. Note : St = Standard, Ba = Basique et Ex = Expert. 8 - Dmx channels and their functions Modes / Channels DMX values Functions and effects St Ba Ex 5 5 1 8-bit PAN movement 000 - 255 PAN movement 16 2 16-bit PAN movement 000 - 255 Very precise PAN movement settings 6 6 3 TILT movement 000 - 2 ...

Page 8 English This menu allows you to visualise the moving head running time, its temperature, and the current version of the internal software. This menu allows you to configure the moving head reactions, adjust the ventilation, customise the display and reset all functions to factory settings. 7.2 INFORMATION 7.3 PERSONALITY Submenus Values Description Time Information Current Time Current running time since the unit was last switched on. Total Run Time Overall running time since the very first time the device was switched on. Last R ...

Page 19 English 12 - Dimensions 270° 287,5 156 181 318,5 95 226 154 243 540° 134 135 Avec la visière 630° 98 ...