Creek Audio 5250 Operating Instructions
Text of the manual
Thank you for purchasing the 5250 amplifier You are now in possession of a State of the Art
Integrated Amplifier The functions and operation of the 5250 and Special Edition are exactly the
same and are very simple However the following notes are provided to explain all aspects of its
design and use
MAINS CONNECTION
When unpacking the a
The loudspeakers should be connected using a suitable pair of cables designed specifically for
audio use. Two pairs of screw terminals marked ’A’ allow for either bare wire or spade lug
connectors to be passed through the hole or around the bush. Tighten the terminal fully after fitting
the speaker wire. Please consult your dealer
The volume control, situated on the right hand side of the front panel, is used to alter the relative
level of the sound output from the amplifier. The volume control is necessary to adjust the level from
one piece of equipment to another. It does not increase the power of the amplifier and if it is found
necessary to have the volume control set
Designed and made in the UK.
2 Bellevue Road, Friern Barnet;
London N113ER, England
Tel: + 44 (0)20 - 8361 4133
Fax: + 44 (0)20 - 8361 4136
E-mail: [email protected]
Internet: www.creekaudio.co.uk
CREEK 5250 & 5250SE SPECIFICATION
POWER OUTPUT (both channels)
STANDARD
50 Watts into 8 Q
SE
60 Watts
POWER OUTPUT (one channel)
60 Watts into 8 Q
70 Watts
Not
