Argus 127 Easy Instruction

color or black and white). Please load your camera in the shade. Unlock the camera by sliding button on bottom In the direction of arrow. Remove back of camera. (Fig. 1) Place the roll of film on the film carrier, marked "Load Here". Fit the end of the film spool into the U·shaped slot in the spring. Press spring back and fit other end of spool into hole at the opposite side of the cavity. (Fig. 2) Be sure printed side of film's backing paper is outermost a's the film is unrolled. Break seal. Draw backing paper into the longer slot of take·up spool. Turn winding knob a few turns in direction of arrows. Make sure film is centered and winding evenly. (Fig. 3)

over camera body. Push together. Then lock camera by sliding button lock in the direc- t ion of arrow. (Fig. 4) WINDING THE FILM. Wind film until num- ber 1 appears in t he red window on back of camera. Now you can take your fi rst picture.

camera at "Color" for average outdoor scenes. In very bright sunlight (beach, snow, etc.), set the knob at B & W. Black & White Film. Under normal outdoor· conditions, set knob at B & W. Under poor light (haze, etc.) set knob at ··Color." Don't set knob between "Color" and B & W. UNLOAD CAMERA IN SHADE. After the final (12th) picture has been taken, wind the film until backing paper disappears in the red window. Now, unlock camera. Push back the holding springs, pull out the film. grasping it to prevent unwinding. Seal with gummed band around film. Then switch empty spool to take up position for your next roll. Continued on back.

Argus Flash Unit, you 're missing lots of fun. You can get one inexpensively from your dealer- ask for the Argus Flash 127. (Fig. 5) INSERT BATTERIES. Loosen screw on back of flash unit with coin. Remove back cover. In· stall two new AA photoflash penlite batteries, one tip up, one tip down, as shown in illustra- tion at right. Replace cover. INSTALLING THE FLASHBULB. Fit the flash unit back on camera. Hold camera and flash unit firmly and push flashbulb into the socket. REMEMBER! Don't put bulb in flash unit before it is attached to camera.

the right settings and camera·to·subject distances for bl.ack·and·white and color films. Use AG·1 bulbs with black·and·white or negative color films. For color· slide films, use AG·IB bulbs. After you take a picture, push the red button on the back of flash unit to eject the bulb. CARE. Please keep your camera clean and free from dust. We suggest you don't leave it in the glove compartment of your car or on car window decks. ALSO, if you aren't using the flash unit, remove batteries to prevent corrosion from battery deterioration. ~" ",1; ARGUS, INCORPORATED 5950 West Touhy Avenue, Chicago 48, illinoiS In Canada: P. O. Box 300, Newmarket, Ontario, Canada PART NO. 9317·1.633 MADE IN USA PRINTED IN USA

Argus, Incorporated Main Office: CUSTOMER SERVICE DEPARTMENT, ARGUS, INCORPORATED 2080 Lunt Avenue, Elk Grove Vil lage, Ill inois 60007 In Canada: Davis Drive East, Newmarket, Ontario For the address of the service location nearest you which is authorized to repair Argus products under guarantee, contact your Argus dealer or write to t he main office of t he Customer Service Department.

Your Argus 127 camera is unconditionally guaranteed by the manufacturer to operate properly for a period of one year from date of original purchase. If, during this period, your camera fails to operate for any reason, Argus, Incorporated will restore it to operating condition at no charge to you. (This includes all parts and labor.) This unconditional guarantee applies to the product itself. We regret that we are unable to assume liability for loss of film or for other expense or inconvenience. This unconditional guarantee is va lid only for the original retail pur- chaser and only if the product is returned prepaid, directly or through an Argus Dealer, to the Customer Service Department, Argus, Incorporated, 2080 Lunt Avenue, Elk Grove Village, Illinois 60007, or one of their au- thorized service locations. The date and place of original purchase must be included, along with a description of the difficulties encountered. Many apparent product difficulties are actually a matter of incorrect usage. It is always wise to see your Argus dealer before returning the product for servicing.