Asus vudu Start Here Manual

©2008 VUDU, Inc. All Rights Reserved. Start Here

This device complies with Part 15 of the FCC Rules. Operation is sub- ject to the following 2 conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference, including interference that may cause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the installation instruc- tions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:  - Reorient or relocate the receiving antenna.  - Increase the separation between the equipment and receiver.  - Connect the outlet into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Prohibition of Co-Location This device and its antenna(s) must not be co-located or used in conjunc- tion with any other antenna or transmitter. Safety Information To maintain compliance with FCC’s RF exposure guidelines, this equip- ment should be installed and operated with a minimum of 20 cm between the radiator and your body. Use only the supplied antenna.

What’s Included (2) Ethernet cables (1) AC to DC power cable Wireless adapter Wireless adapter

one end to the wireless adapter marked Connect the other end to your home network router or modem. . 1.

one end into the DC-IN socket of Plug the other end into a wall outlet. 2. .

Connect one end to the wireless adapter marked . Connect the other end to your VUDU box. 1.

Insert one end into the DC-IN socket of Connect the other end to one of the USB ports on the VUDU box—on the back or left side. 2. .

will light up. 3. The LED indicators for Power and Ethernet on will light up and, after a few seconds, the LED indicator for Wireless will start blinking. The wireless adapters have been set up successfully. Going forward, all three LED indicators on both wireless adapt- ers should be illuminated. When the LED indicators for Wireless and Ethernet start to blink, data is being transmitted. Should you have any questions or problems, please refer to the Wireless Kit Instructions at www.vudu.com/vudu_documenta- tion.html or call Customer Care at 1-888-554-8838 (VUDU).