AMP HSN1 Quick Start Manual
Read Online
Read the AMP HSN1 Quick Start Manual online using the built-in PDF viewer.
Text of the manual
For Technical Support, Contact AMP
at (775) 345-9933 (9 am - 5 pm PST)
or [email protected]
Connect amplifer RF output SMA connector to antenna
Connect the RF output from the CNT1 video transmitter to
RF input SMA connector.
STEP
STEP
STEP
Note
When setting up your system, the transmit and receive
antennas should be greater than 25 feet apart to
prevent serious damage to or destruction of the
receiver’s front end
HSN1 Power Amplifer Quick Start Guide
Connect power, Communications (if required), and
enable inputs to the MDM-9P connector *see reverse side
Advanced Microwave Products
PO Box 1437
2465 Old Highway 40 West, Suite 200
Verdi, NV 89439
How to Confgure Your Amplifer
The HSN1 power amplifer does not require any confguring unless it includes optional variable
output level. If included, the power level is set via commands using the Comm port. See the HSN1
Interface Control Document (ICD) for more details.
SMA Female
RF Input
SMA Female
RF Output
Wiring Your HSN1 Power Amplifer
MDM-9P
Power & Confguration
1:
2:
3:
4:
5:
6:
7:
8:
9:
+11 to 16 VDC Input
Ground
Ground
Ground
Enable (Open=On, Ground (or <1.5 Vdc)=Of)
NC/Tx Comm-
Tx Comm+
Rx Comm+
NC/Rx Comm-
1
5
6
9
