d&b audiotechnik Vi7P Manual 

By factory default, the HF horn is fitted to the cabinet providing the nominal horizontal dispersion when the cabinet is used in upright position. This is indicated by a white label on the horn flange. The label is visible through the front grill on each side of the cabinet as shown in the graphic opposite. The HF horn can be rotated through 90°. Tools required: Torx wrench (#TX20). 1. Undo the torx screws on the top and bottom panels of the cabinet and remove the front grill. 2. Undo the screws holding the horn flange and rotate the horn. 3. Refit the horn as ...

Potential risk of personal injury Never stand in the immediate vicinity of loudspeakers driven at a high level. Professional loudspeaker systems are capable of causing a sound pressure level detrimental to human health. Seemingly non-critical sound levels (from approx. 95 dB SPL) can cause hearing damage if people are exposed to it over a long period. In order to prevent accidents when deploying loudspeakers on the ground or when flown, please take note of the following: – When setting up the loudspeakers or loudspeaker stands, make sure the ...

Vi7P/Vi10P system data Frequency response (–5 dB standard) 59 Hz - 18 kHz Frequency response (–5 dB CUT mode) 100 Hz - 18 kHz Max. sound pressure (1 m, free field) Vi7P with D12/D20/30D 139 dB Vi7P with D80 142 dB Vi10P with D12/D20/30D 138 dB Vi10P with D80 141 dB (SPLmax peak, pink noise test signal with crest factor of 4) Input level (100 dBSPL/1 m) –17 dBu Vi7P/Vi10P loudspeaker Nominal impedance 8 ohms Power handling capacity (RMS/peak 10 ms) 500/2000 W Nominal dispersion angle (horizontal) Vi7P 75° Nominal dispersion angle (horizontal) Vi10P 110° Nom ...

Potential risk of personal injury Never stand in the immediate vicinity of loudspeakers driven at a high level. Professional loudspeaker systems are capable of causing a sound pressure level detrimental to human health. Seemingly non-critical sound levels (from approx. 95 dB SPL) can cause hearing damage if people are exposed to it over a long period. In order to prevent accidents when deploying loudspeakers on the ground or when flown, please take note of the following: – When setting up the loudspeakers or loudspeaker stands, make sure the ...

Vi7P/Vi10P system data Frequency response (–5 dB standard) 59 Hz - 18 kHz Frequency response (–5 dB CUT mode) 100 Hz - 18 kHz Max. sound pressure (1 m, free field) Vi7P with D12/D20/30D 139 dB Vi7P with D80 142 dB Vi10P with D12/D20/30D 138 dB Vi10P with D80 141 dB (SPLmax peak, pink noise test signal with crest factor of 4) Input level (100 dBSPL/1 m) –17 dBu Vi7P/Vi10P loudspeaker Nominal impedance 8 ohms Power handling capacity (RMS/peak 10 ms) 500/2000 W Nominal dispersion angle (horizontal) Vi7P 75° Nominal dispersion angle (horizontal) Vi10P 110° Nom ...

The following graphs show dispersion angle over frequency of a single cabinet plotted using lines of equal sound pressure (isobars) at –6 dB and –12 dB. Isobar diagram horizontal Vi7P vertical setup Isobar diagram vertical Isobar diagram horizontal Vi7P horizontal setup, horn rotated Isobar diagram vertical d&b Vi7P/Vi10P Manual 1.1 en 9 ...